Sony MJ-L1 MJ-L1A operating instructions Precautions, Maintenance

Page 29

For Your Information

Precautions

Maintenance

Guide to the Serial Copy

Management System

System Limitations of MD

MD Display Messages

Troubleshooting Guide

Specifications

Index to Parts and Controls

Index

Precautions

If you have any questions or problems concerning your stereo system, please consult your nearest Sony dealer.

On safety

•The use of optical instruments with this product will increase eye hazard.

•The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off.

•Unplug the system from the mains if it is not to be used for an extended period of time. To disconnect the mains lead, pull it out by the plug. Never pull the cord itself.

•Should any solid object or liquid fall into a component, unplug the stereo system and have the component checked by qualified personnel before operating it any further.

•AC power cord must be changed only at the qualified service shop.

On installation

Place the stereo system in a location with adequate ventilation to prevent heat build- up in the stereo system.

On condensation in the CD player and the MD deck component

If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the CD player or the MD deck. Should this occur, the CD player or the MD deck will not operate. Remove the CD or the MD and leave the system turned on for about an hour until the moisture evaporates.

Notes on handling MDs

Because the MD itself is housed in a cartridge, you can handle it normally without being concerned about dirt or fingerprints. However, malfunctioning may result if the cartridge itself is dirty or warped.

Do not open the shutter on the MD cartridge

Trying to force the shutter open will damage the shutter.

Shutter Cartridge

In case colour irregularity is observed on a nearby TV screen (For Mj-L1 only)

With this magnetically shielded type of speaker system, the speakers can be installed near a TV set. However, colour irregularity may still be observed on the TV screen depending on the type of your TV set.

If colour irregularity is observed...

Turn off the TV set once, then turn it on after 15 to 30 minutes.

If colour irregularity is observed again...

Place the speakers farther away from the TV set.

Maintenance

To clean the cabinet

Use a soft cloth slightly moistened with mild detergent solution.

To clean the CD

When a CD is dirty, clean it with a cleaning cloth. Wipe the CD from the centre out.

Notes on CD

•Do not use solvents such as benzene, thinner, commercially available cleaners, or anti-static spray intended for vinyl LPs.

•If there is a scratch, dirt or fingerprints on the CD, it may cause a tracking error.

Notes on MD

•Do not expose the MD to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be a considerable rise in temperature inside the car.

•Periodically remove dust and debris from the cartridge surface by wiping it with a dry cloth.

For Your Information

29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Flat Component System MD § Before Using This UnitWelcome Table of Contents Connecting Aerials Connecting StereoConnecting the Speakers For MJ-L1 only Connecting Power Inserting BatteryTo a wall outlet Front speakerTo check the time while power is on Setting the ClockTo correct the clock setting FlashingPlaying a CD normal play Power m onTrack Playing Music Number Time Calendar Numeric buttonsPlaying Tracks Repeatedly repeat play Using the DisplayPlaying Tracks in Random Order shuffle play To select tracks using the number buttons on the remotePlaying Tracks in the Desired Order programme play To play the tracks in original orderCD disc memo function Assigning a Name toTo check the name To delete a nameLabel side up Arrow pointing toward the MD deck Playing an MD normal play2 JOG Current track number Remaining time on the track Track Playing Music Number time CalendarRemaining time Track name Disc nameTrack number To cancel shuffle playGo to previous Go to next Track Track Marking Before RecordingDigital Recording and Analog Recording Recording from the Radio Recording a CDStop Recording on an MD ManuallyJOG 1 Marking Track Numbers While RecordingMarking Track Numbers Automatically Level synchro function To cancel level synchro2 „ Erasing Recordings erase functionErasing a single track Erasing all tracksErasing part of a track Dividing Recorded Tracks Divide functionMoving Recorded Tracks Move function Labelling Recordings title function Combining Recorded Tracks Combine function2 6 0 To stop before the track has been dividedTo check the titles Nuppercase nlowercase Space Nsymbols NnumbersNTo stop before the track has been labelled To improve AM broadcast reception When the desired station is not tunedListening to Radio Assigning a Name for a Preset Station station name Presetting Radio StationsTo change the preset number 3,6To erase the station name Playing Preset Radio StationsTo change the display FrequencyTo listen through the headphones Adjusting the SoundTo change the remaining time while the sleep timer is on To cancel the sleep timerFalling Asleep to Music Waking Up to MusicTo cancel the timer Timer-Recording Radio ProgrammesTo change the timer 5,6 4,5Connecting a stereo cassette deck Connecting Optional EquipmentCassette Deck To listen to the sound from the cassette deckMaintenance PrecautionsRule Guide to the Serial Copy Management SystemSystem Limitations of MD Limitations when recording over an existing trackMD Display Messages Some tracks cannot be combined with othersTroubleshooting Guide Restoring the Factory Settings SpecificationsIndex to Parts and Controls Front PanelRemote RM-SMJ1 Rear PanelDisplay Window MiniDisc deck section Amplifier sectionIndex For Your Information
Top Page Image Contents