Care and Cleaning | (continued) |
5. Set the card on the card tray.
Place the card in right direction. See p.21.
6. | Press the ENTER button, select “MG Head” with | |||
| the ↑ or ↓ button, and press the ENTER button. | |||
|
|
|
|
|
|
| > > M G H e a d | ||
|
|
|
| O K ? |
|
|
|
|
|
|
| ENTER |
| |
|
|
|
|
|
|
|
|
|
|
C l e a n i n g . .
7. When the cleaning card is discharged from NG card discharge slot, turn off the power of the printer. Wait for 10 seconds before turning on the power again.
CAUTION
Replace the magnetic head cleaning card when it gets dirty. A dirty card may pollute the head
and cause damages to the head.
Consult your dealer on the alcohol and cleaning card.
Cleaning of the bobbin holders
Dirt on the bobbin holders may appear on the card or the film, cause defects on the card. Clean the bobbins when replacing ink ribbon or retransfer film.
1. Remove the cassettes of ink ribbon and retransfer film.
See p.15 and 17 of this manual.
2. Wipe 4 bobbin holders with
Once printer servicing and cleaning
have been completed
Once servicing and cleaning of the printer have been completed, check to make sure that all parts have been replaced properly.
Improper replacement of parts may result in the power not turning on or in operating errors.
Periodical Maintenance
Periodical maintenance by the service personnel is recommended to avoid print error and failure. Consult your dealer for maintenance period and cost.
40
