Operation (continued)
Buzzer mode setting | Power saving mode settings |
The buzzer indicating errors can be turned on or off.
> B u z z e r | EXIT |
Exit user mode
O n
Set the buzzer:
there are two settings
(On, off)
|
|
| ENTER |
|
Press |
|
| to select the setting and press | to save. |
| (The electronic beep sounds.The beep will not sound |
| ||
if the buzzer mode setting is set to off.)
When Off is specified,
•electronic beep sound indicating an error,
•electronic beep sound indicating the number of cards, and
•electronic beep sound indicating settings saved with the ENTER button in the user mode are muted.
The printer enters into the power save mode after a specified period of time if none of operation buttons are touched in the Ready state. The heat roller for retransfer, bend remedial roller, and
> P o w e r S a v i n g | EXIT |
Exit user mode
o f f
Power saving settings:
there are 9 options.
|
|
|
| ENTER |
|
Press |
|
|
| to select the setting and press | to save. |
| (The electronic beep sounds.The beep will not sound |
| |||
if the buzzer mode setting is set to off.)
Press the EXIT button to cancel the user mode, and the printer starts.
Off:
Not in power saving mode.
Setting options: [5,10,15,20,25,30,45,60] (units: minutes) If printing is not to be carried out for a period longer than the
set time, switch the unitís heater off. (Power save status)
“Sleeping” appears on the LCD panel in the power save mode. The operation buttons are disabled in this mode. See step 2 in “Canceling the power save mode” to enable the operation buttons.
S l e e p i n g
The printer moves to the power save mode when the specified time arrives even if you turns off the printer and turn it on again.
Canceling the power save mode 1. From the host computer
Enter a control command to print the card. The power save mode is cancelled, and printing automatically starts upon completion of preheating.
2. Temporary cancellation
To cancel the power save mode temporarily on the
printer, press | RESET | , then | ENTER | to initialize the printer. |
|
|
3. Permanent cancellation
Cancel the power save mode temporarily as described in step 2, and change the power save mode setting to OFF.
33
