Ultra electronic Prima 2e instruction manual Card Thickness setting mode

Operation

(continued)

Setting the bend remedy mode

CAUTION

Single-sided printing may cause a bend depending on the

When printing on both sides is done

cards. Adjust the setting to get rid of the bend.

with “Remedy roller temperature setting” set to a high

EXIT

temperature, the cards may show a large deformation.

> B e n d R e m e d y >

Exit user

Please set this item to OFF for printing on both sides.

mode

ENTER

Set the bend remedy roller temperature

There are 7 bend remedy roller temperature settings:

> > T e m p L e v e l

(off and from –5 to 0 the larger the value the higher the temperature).

o f f

ENTER

EXIT

MENU

Press

to select the setting and press

to save.

(The electronic beep sounds.The beep will not sound

if the buzzer mode setting is set to off.)

RESET

ENTER

*After exiting the user mode, press

and then press

to initialize.

If initialization is not carried out, the temperature setting will have no effect on the printer.

Bend remedy speed settings

> > S p e e d

5 gradations can be set

- 2

(from –2 to +2, the larger the value the faster the speed.)

ENTER

EXIT

MENU

Press

to select the setting value and press

to save.

(The electronic beep sounds.The beep will not sound

if the buzzer mode setting is set to off.)

Cooling time setting:

> > C o o l i n g T i m e

- 2

16 gradations can be set (none and 1-15, unit: seconds).

EXIT

MENU

Press

ENTER

to select the setting value and press

to save.

(The electronic beep sounds.The beep will not sound

if the buzzer mode setting is set to off.)

	CAUTION		If the bend remedy temperature
						Card Thickness setting mode
setting is set to off from any other setting, the preheating
status will remain the same until the roller temperature
				The printer is designed to load only the 0.76mm or 0.25mm
falls (for approximately 10 minutes).
This is not a malfunction. Leave the unit in ready status				thick cards. So set card thickness depending on the card
and wait.				used.
									EXIT
					> C a r d T h i c k n e s s
										Exit user mode
Memo		1.Setting temperature and speed of the					S t a n a r d
				Set the card thickness:
bend remedial roller. Adjust the “roller
				2 settings
temperature” setting in principle to correct the
				[Standard and Thin]
bend of the card, and use the “correction										ENTER
speed” setting for fine adjustments.
					Press			to select the setting and press			to save.
2. Setting waiting time for cooling the card						(The electronic beep sounds.The beep will not sound
This provides the time for a special film, which						if the buzzer mode setting is set to off.)
will be marketed in the future, to cool down to
						Standard:	0.76mm(0.03inches)-thick
prevent the card and retransfer film from						Thin: 0.25mm(0.01inches)-thick
sticking together after printing.
					For changing card thickness, see “switching the card
					thickness” on Page 21 of this manual

34