Set-up (continued)
When using magnetic cards
When using cards with magnetic strips, set the cards in the following manner.
For JIS II cards:
Place the card with its magnetic stripes upward and facing the card bracket.
For ISO cards:
Place the card with its magnetic stripes downward and facing the card bracket.
CAUTION
Printing on cards with magnetic strips is not guaranteed.
When using contact IC cards
When using contact IC cards, set in the following manner.
Place the IC card with its IC terminal inward and facing the card bracket.
Loading cards
Load cards when the printer’s LCD panel shows the message “Ready” or “No Card”, and not when printer operations have stopped due to an error. Cards can
also be loaded when the power supply is not switched on. If there is a drop in the volume of remaining cards (under about 25 cards with a thickness of 0.76mm), the electronic beep sounds before every feeding.
(See p.33 in this manual.)
R e a d y | N o C a r d |
OR
L o a d i n g
When “Loading” is displayed on the LCD panel, do not open the card tray under any circumstances.
The unit is currently feeding cards. If a message other than the one above is displayed, cards can be loaded even while the unit is printing. However, you are recommended to load cards when the unit is not printing.
To prevent defective printing caused by suspended printing or vibration as a result of opening and closing the card tray, load cards with care.
Switching the card thickness
Depending on the material, some 0.25mm(0.01inches) thick cards may not be suitable for printing. Consult your dealer regarding the materials and specifications of the card before purchasing.
WARNING
•As for switching the card thickness,consult your dealer or the service personnel. Otherwise injuries or malfunction of the printer may be caused
Electric shock
Injury
21
