Initial Setup
Adjusting CRT Color Convergence
This TV has three color projection tubes: one for red, green, and blue. When mixed together in the proper portions, the output of these three color tubes can produce any color. To produce these colors, however, the beams must be precisely aligned over each other so that the colors can be mixed. The produce of aligning these picture beams is called “convergence”.
Attention:
•Please have your TV on for at least 20 minutes before using this feature.
•This adjustment will be needed only when the colors of the characters/lines are separated and lack in distinction. If not, please don’t perform the adjustment.
Colors may become separated after the TV has been moved, or over a long period of time if regularly subjected to low levels of vibrations. If the colors become separated, please perform the adjustments below again. In the beginning, please be sure to perform AUTO convergence adjustment.
Auto
Press the MENU button
π† To CONVERGENCE √® To Enter
π† To select “AUTO” (The convergence adjustment will start. It will take about 50 seconds).
When the adjustment is finished, it will return to what you were watching.
����������� |
|
| |
���� |
|
|
|
������ |
|
|
|
����� |
|
|
|
������ | ������� | ���� | ���� |
| |||
| ����������� |
|
|
Note:
•You can reset the adjustment if you do not like the results. See the next page.
•If you want to adjust it more, you can perform the manual color convergence adjustment. See the next page.
•You can also access this feature by pressing the SUPER FOCUS button on the front panel of your TV.
INPUT- 4
AUDIO |
|
|
| |
OVER | L / MONO R | MENU CHANNEL | VOLUME SUPER | |
|
| – + | – + | FOCUS |
|
| OPERATE |
|
|
OPEN |
|
|
| SUPER |
|
|
|
| FOCUS |
40