Datavideo VDR-3000 instruction manual Select the video input source, Select the audio input source

2

The VDR 3000 will take a few moments to prepare the disk for recording. If CDDVD, DVD- PHOTO, HQ-VCD, VCD or SVCD has been selected then once prepared the VDR 3000 start up screen will disappear and the system will be ready to start recording. If CD-DA is selected the VDR 3000 start up screen will remain on the TV.

Select the video input source:

DV Input (Option): To select a DV input source, set the slide switch on the rear panel to

DV position. Analog Input: To select the analog video input, set the slide switch on the rear panel to VIDEO position. To select an analog video format by pressing the “VIDEO INPUT” key on the remote controller. The “Video” will appear on the screen. Press the “VIDEO INPUT” key again to cycle through Video and S-Video source and press the “ENTER” key to select the desire video source.

Note: The default setting is composite video input mode.

Select the audio input source:

Press the “AUDIO INPUT” key on the remote controller to select the digital audio or analog audio input source. Note: The default setting is set at analog audio input mode.

Select the video output format:

Press the “VIDEO OUTPUT” key, the video output format would be cycle shown on the top of TV screen:

Video/S-Video

Sony Betacam

Mastushita M2

SMPTE

R.G.B.

The Sony Betacam, Mastushita M2 and SMPTE format are all output with component Y.U.V. video format with slight different level. Press the “VIDO OUTPUT” key till find the format you want. The default setting is set at Video/S-Video format. Note: Please don’t hook up the video cables to Y.U.V./R.G.B. and Video/S-Video connectors at same time. It will cause the incorrect (lower) video output level.

NOTE: The VDR-3000 will return to default settings when powered on.

2Screen Shots are simulated.

19