Motorola DCT6400 Regulatory Information, Declaration of Conformity, Important Safety Instructions

Page 5

IMPORTANT SAFETY INSTRUCTIONS

23Battery usage

Notwithstanding any information provided by Motorola in this manual regarding the use of batteries, the end user assumes all responsibility and liability to use and dispose of batteries in accordance with all applicable laws, rules and regulations. Motorola will not be liable to anyone for the end user's failure to use and/or dispose of batteries in the proper manner and in accordance with such laws, rules and regulations, or for any defect contained in batteries which may cause injury damage to persons or property.

24Heat

This product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

Regulatory Information

Federal Communications Commission Radio and Television Interface Statement for a Class ‘B’ Device

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in the residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If the equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

•Increase the separation between the equipment and the affected receiver

•Connect the equipment on a circuit different from the one the receiver is on

•Ensure that the cover plate for the security card is secured and tight

Changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Declaration of Conformity

According to 47 CFR, Parts 2 and 15 for Class B Personal Computers and Peripherals; and/or CPU Boards and Power Supplies used with Class B Personal Computers, Motorola, Inc., 6450 Sequence Drive, San Diego, CA 92121, 1-800-225-9446, declares under sole responsibility that the product identifies with 47 CFR Part 2 and 15 of the FCC Rules as a Class B digital device. Each product marketed is identical to the representative unit tested and found to be compliant with the standards. Records maintained continue to reflect the equipment being produced can be expected to be within the variation accepted, due to quantity production and testing on a statistical basis as required by 47 CFR 2.909. Operation is subject to the following condition: This device must accept any interference received, including interference that may cause undesired operation. The above named party is responsible for ensuring that the equipment complies with the standards of 47 CFR, Paragraphs 15.101 to 15.109. The Class B digital apparatus meets all requirements of the Canadian Interface Causing Equipment Regulations.

Page 4 Page 6
Image 5
Page 4 Page 6
Contents MSGS ON INFO MENU POWERRECORD REMOTE OPTION GUIDE SELEC TDO NOT REMOVE COVER OR BACK NO USER-SERVICEABLE PARTS INSIDE NOTE TO CATV SYSTEM INSTALLERREFER SERVICING TO QUALIFIED SERVICE PERSONNEL REPAIRSIMPORTANT SAFETY INSTRUCTIONS Page Declaration of Conformity Regulatory Information23 Battery usage 24 HeatYou may not Software LicenseSOFTWARE LICENSE You may Contact Us Canadian ComplianceDCT6400 Series User Guide CONTENTSTroubleshooting Data FeaturesRecording Your Connections Data DevicesINTRODUCTION Pass Card FRONT PANELCABLE Y Pb Pr BACK PANELAC Switched Outlet Adjusting the Volume Turning Power On and OffChanging Channels Interactive Program GuideDIGITAL VIDEO RECORDER DVR What is DVR?Simultaneously Record Two Shows and Watch a Recorded Program Simultaneously Record Two ShowsRecord two programs from two different channels at the same time OPTIMIZING YOUR DCT* FOR HIGH DEFINITION TV Page User Settings DCT6400 Series User GuideIf you are not using an HDTV with the DCT*, selecting a blank. If this occurs, you can view the settings on the LEDSets the opacity of the closed captions foreground. Defaults to 480i, this setting defaults to OFF and cannot be changedprogramming to fill your widescreen display. Stretch can Turns closed captions off or on. The LED panel displays theDescription ON-SCREEN GRAPHICS The YPbPr Output setting can be configured from the on-screen menuCONNECTING YOUR DCT Component video Y Pb Pr - HDTV and SDTV Video Connection OptionsS-Video - SDTV RF Input - SDTVV E N T I L A T E Important Safety ConsiderationsDCT6400 Series CONNECTING YOUR DCT* TO A HDTV - VIDEO ONLYHDTV IEEEIEEE Connecting HDTV - Video OnlyAudio Optical connection connection CONNECTING YOUR DCT* TO A HDTV - AUDIO ONLYOptional INPUTConnecting HDTV - Audio Only Either / or CONNECTING YOUR DCT* TO AN A/V RECEIVER - AUDIO ONLYDCT6400 Series A/V receiverOptical OPTICAL SPDIF Connecting an A/V Receiver - Audio OnlyDCT6400 Series CONNECTING YOUR DCT* TO A STEREO TVStereo TV S-VideoConnecting a Stereo TV Cable in CONNECTING YOUR DCT* TO A STEREO TV AND STEREO VCRStereo VCR Stereo TVConnecting a Stereo TV and Stereo VCR Stereo VCR CONNECTING YOUR DCT* TO AN A/V RECEIVER, TV, AND VCRStereo TV A/V receiverConnecting an A/V Receiver, TV, and VCR HDTV / SDTV RECORDING YOUR CONNECTIONSStereo receiver A/V receiverDATA DEVICES Data FeaturesPossible Solution TROUBLESHOOTINGProblem Verify that the MUTE button on the DCT* or the remote on the TV screen There is no videoThere are no graphics, closedWide screen TVs display 43 programs in this format There are black This may occur on a 43 TV if the 43 OVERRIDE setting
Top Page Image Contents