DVR4C Installation Manual Menu system
EN 17
•Fill in the IP, subnet mask and default gateway addresses when DHCP is set to Off.
•Fill in the DNS in order to use an
•Set
>
•Set the Bandwidth limit throttle to restrict the network bandwidth used.
>>> XDSL
•Specify the Username and Password for an xDSL connection if required.
•When connected, the status shows Connected.
>>> HTTP PORT
•The DVR provides flexible network communication port configuration. If the DVR is on a special network, the HTTP port can be changed to the appropriate number. For network communication port information, ask your network administrator.
•The default is 80.
>>> COM PORT
•Configure the single
•Select Device with the up/down keys.
•If a modem is selected, an initialisation command can be entered.
•Select appropriate values for serial communication for Baud rate, Parity, Stop bits and Data bits.
>>> PSTN DIAL-IN
•Remote users who have a PSTN connection via a modem can access the DVR.
•If you select Use default IP, the DVR automatically provides a
•Select Custom to specify exact IP addresses for both the DVR itself and the client PC.
>>> E-MAIL SETUP
The DVR can send an
•If Status is set to On, an
•Specify a recipient address and an
•Select the number of images to be sent attached to the
>>INPUTS AND OUTPUTS
Inputs and outputs can be configured in this menu as Normally Closed (NC) or Normally Open (NO).
•Select either NC or NO with the up/down scroll keys. Press the play key to confirm.
•Outputs have the following fixed purpose:
Item | Purpose | Remote access |
Output 1 | Activated only on | Not allowed |
| Input Alarm |
|
Output 2 | Activated only on | Not allowed |
| System failures |
|
Output 3 | Not assigned for local | Allowed |
| control |
|
Output 4 | Not assigned for local | Allowed |
| control |
|
•Select Relay Dwell time ranging from 0 to 60 seconds on the selection slider with Left/Right scroll keys and press the play key to confirm. When Follows is selected, the output relay is active until the event causing it ceases to be active.
Bosch Security Systems Version 1.1