Havis-Shields PT-VIDEO-MDVR manual Mdvr main Harness wire connections 25-pin connector

MDVR main Harness wire connections (25-pin connector)

Red – Power (direct 12 volt positive)

Black – Ground (12 volt negative)

Yellow – Ignition (switched 12 volt positive)

Green – Trigger 1

Orange – Trigger 2

Brown – Trigger 3

Blue – Trigger 4

Gray – Trigger 5

NOTE 1:

Trigger connections are pre-set (default) to activate on positive Switching. They can be changed to negative switching by changing MDVR settings in trigger Menu. (High = Positive / Low = Negative)

NOTE 2:

For correct operation, it is very important to connect the main power to a constant 12V supply (not switched) and the Ignition trigger to the ignition power supply (switched).

•RCA to RCA 6 foot Cable # GSM70024

Monitor Video OUT to MDVR Video IN (use yellow connectors) MDVR Video OUT to Monitor Video IN (use white connectors) Red connector not used (see NOTE 3A below)

•RCA to Camera input adaptor. (# GSM70026) (Use yellow RCA connector - Red not used)

5