TRIDENT PROTECTION CIRCUITRY
Your RUBICON amplifier is protected against both overheating and short circuits by means of main power supply fuses and the following circuits:
+Speaker Protection
+Ground Fault Differential
+A
NO7E: #yuu,experience bhvvr~ m&n pm&w suppiy fuses, it is Ifkeg 
thiat th.e am@&w is seeing a dead &wt, either in the speaker w/m or in ttw speaker its&. /%x%i~ the prubiem before blowing mMip/e fuses! DO lVC?Tincrease va/ues beyond #e otigirial fuse value! DcMg so wil widyuur warrantand may damage yauramp#i&.
PROBLEM |
|
| CAUSE | |
|
|
| ||
No sound and fuse light (204 & |
| Fuse is blown, replace fuse with proper | ||
604 only) is lit. |
| value. | ||
|
|
| ||
No Sound and Power LED is not |
| 1. No power or ground at the amp. | ||
2. | No remote | |||
lit | ||||
3. | Blown fuse near the battery | |||
| ||||
|
|
| ||
| 1. | No signal input | ||
|
| 2. The AIRBASS/Accessory switch is in the | ||
No sound, Power LED is lit. |
| “IN” position. Remove bottom plate and | ||
|
| move the switch to the “OUT’ position (404 | ||
|
| & 604 only). | ||
|
|
| ||
Repeatedly blow amp fuse; |
| I. Speaker or leads may be shorted | ||
frequent activation Trident | 2. | Too low of a load on amplifier | ||
Protection | 3. | Verify adequate amp ventilation | ||
|
|
| ||
No output from channels 3&4 with |
| Switch CH3&4 Input Select to “CH1&2”on | ||
1 pair of RCA inputs |
| the top of the amp | ||
|
|
| ||
In 3 channel mode, fade capability |
| Make sure Ch’s l&2 are H.P. on satellite | ||
does not operate with 2 pairs of |
| speakers and Ch’s 3&4 are L.P. on | ||
RCA inputs |
| subwoofer speakers, | ||
|
|
|
| |
Your Soundstream RUBICON amplifier is protected by a limited warranty. Please read the enclosed warranty card for details.
SPECIFICATIONS
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 4 n Stereo | 2 Q Stereo | 1 n Stereo |
|
|
|
|
| ||
| MODEL |
| (8 Q Bridged) | (4 Q Bridged) | (2 Q Bridged) | iirE’ |
| ||||||
|
|
|
| (12.5 Vdc) | (12.5 Vdc) | (12.5 Vdc) |
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| I | 204 | I | 25Wx4 | 5owx4 |
| NA |
| 200 |
|
|
| |
| (5OW x 2) | (1 oow x 2) |
| I |
| I |
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| I | 404 | I | 5owx4 | 1oow x4 | lOOWx4 |
|
|
|
|
| ||
| (1 oow x 2) | (2OOW x 2) | (2OOW x 2) | I | 4oo |
|
| I | |||||
| I | 604 | I | (160W x 2) | (3OOW x 2) | (3OOW x 2) | I | 6oo | I |
| |||
|
|
|
| 8OWx4 | 150w x4 | 15owx4 |
|
|
|
|
| ||
THD |
|
|
|
| cO.l% |
|
|
|
|
|
|
| |
Signal to Noise | >lOOdB |
|
|
|
|
|
|
| |||||
Frequency |
| Response | 20 Hz to 20 kHz * 0.5 dB |
|
|
|
|
| |||||
Stereo Separation | >90 dB |
|
|
|
|
|
|
| |||||
Damping |
|
|
| >200 |
|
|
|
|
|
|
| ||
Input | Sensitivity | 300 mV to 5.0 Volts |
|
|
|
|
| ||||||
Input | Impedance | 1 Ok Ohms |
|
|
|
|
|
|
| ||||
Crossover Specificafions
Low Pass: 30 Hz - 120 liz at 24 dB/Octave (12 dB/Octave for 204)
High Pass: 65 Hz - 220 Hz at 12 dB/Octave
Hawkins Bass Confrol
0 to +9 dB Boost(404 & 604) +6dB Boost(204) (Hawkins Bass Control “IN”) Boost Frequency = 45 Hz
Sub Sonic filter frequency = 13 Hz
Dimensions (W x D x H)
RUBlCON204: 11” X 9.8” X 2.25” | (279mm X 288mm X 57mm) |
RUBlCON404: 15” X 9.8” X 2.25” | (381 mm X 288mm X 57mm) |
RUBlCON604: 17.25” X 9.8” X 2.25” | (437mm X 288mm X 57mm) |
22