RUBICON
-
TOP VlEW | FRONTVIEW | BonoMvlEw(F3v4Tuu) |
KEY TO CALLOUTS
1.FUSE LED - Indicates blown fuse.
2.POWER LED - Indicates amplifier power.
3 . Subsonic / Hawkins Bass Control Switch - “SUBSONIC” to engage the Sub Sonic filter at 13 Hz. “HawkinsBass Control” to engage the high pass filter @ 45 Hz with
4 . XOVER Switch - (Channels l&2) Select “L.P.for” use with the internal low pass filter, “IN”for use with the internal high pass filter, or “OUT” for use with external crossover.
5.XOVER Switch - (Channels 3&4) Select “L.P.” for use with the internal low pass filter, “H.P.”for use with the internal high pass filter, or “OUT” for use with external crossover.
6.Inputs - Right and left channel RCA inputs for channels 3&4.
7.Input LEVEL - Channels 3&4 input level control.
0.High Pass Control Adjustment - (Channels 3&4) crossover frequency control for the internal high pass filter.
9Speaker Connection Terminal - Speaker connections for Ch’s 3&4. lb. Inputs - Right and left channel RCA inputs for channels l&2.
I l . Input LEVEL - Channels l&2 input level control.
12.Low Pass Control Adjustment - Crossover frequency control for the in- ternal low pass filter. Applies to any channel with the low pass filter en- gaged.
13.High Pass Control Adjustment - (Channels l&2) crossover frequency control for the internal high pass filter.
14.LINE OUTPUTS - Full range outputs to external amplifier. Note: Signal is driven from channel l&2 inputs.
15.Speaker Connection Terminal - Speaker connections for Ch’s l&2.
16.REMOTE - Remote
17.GND - Main ground connection. Bolt to a clean chassis point in the vehicle.
18.+12V - Connected to a fuse or circuit breaker, then to the battery’s positive terminal
19.Main Fuse - Main power supply fuses.
20.Stereo/Mono Switch - (Channels l&2) Select “MONO” for bridged mono output (use right RCA input only). Select “STEREO” for stereo output.
21.Channels 3&4 INPUT SELECT - Selectable inputs from internal (from channels l&2) or external (from channels 3&4 local RCA inputs).
22.Stereo/Mono Switch - (Channels 3&4) Select “MONO”for bridged mono output (use right RCA input only). Select “STEREO”for stereo output.