Basic Operations
Switching the system on/off
●Press
➜“HELLO” is displayed briefly.The system will switch to the last selected source.
●Press DISC, TUNER or AUX on the remote.
➜The system will switch to the selected source.
To switch the system to standby mode
●Press
Volume control
Turn VOLUME
➜”VOL XX” is displayed on the display panel. “XX” denotes the volume level.
To switch off the volume temporarily
●Press MUTE on the remote.
➜ Playback will continue without sound and “MUTING” flashes.
●To activate sound reproduction, you can:
– press MUTE again;
– adjust the volume controls;
– change source.
Sound Control
DBB and DSC sound features cannot be activated at the same time.
DBB (Dynamic Bass Boost)
DBB enhances the bass response.
●Press DBB on the remote to enable/disable DBB feature.
➜ Some discs might be recorded in high modulation, which causes a distortion at high volume. If this occurs, switch off DBB or reduce the volume.
DSC (Digital Sound Control)
DSC provides a different type of preset sound equalizer setting.
●Press DSC on the remote repeatedly to select: FLAT, POPS, JAZZ, CLASSIC or ROCK.
Selecting surround sound
IMPORTANT!
For proper surround sound, make sure the speakers and subwoofer are connected (see
●Press SURROUND to select surround or stereo mode.
➜The availability of the various surround sound modes depends on the number of speakers used and the sound available on the disc.
➜The center and surround speakers operate only in
➜The available output modes for multichannel include: Dolby Digital, Dolby Pro Logic or Dolby Pro Logic II surround sound.
➜Stereo broadcasts or recordings will produce some surround channel effects when played in a surround mode. However, monaural (single channel sound) sources will not produce any sound from the rear speakers.
Dimming the display screen
●Press DIM repeatedly to select different levels of brightness for the display screen.
English
19