Preparation
Inserting batteries into the Remote Control
1Open the battery cover.
2Insert batteries (AA size) with the correct polarity as indicated by the + and - symbols
inside the battery compartment.
3Close the cover.
- | + |
+ | - |
CAUTION!
–Remove batteries if they are exhausted or not to be used for a long time.
–Do not use old and new or different types of batteries in combination.
–Batteries contain chemical substances, so they should be disposed off properly and kept away from children.
NTSC/PAL Conversion
This player is equipped with an NTSC/PAL conversion feature that converts the video output of the disc to match your TV system. To activate the conversion refer to page 13.
Switching On
1Connect the AC power cord to the power outlet.
2Switch on the TV and DVD player.
3Set the TV to the correct Video IN channel. (eg. EXT1, EXT2, AV1, AV2, AUDIO/VIDEO, etc. (Refer to your TV owner’s manual for detail) ➜ The player display lights up and the default screen appears on the TV.
4If you are using an external equipment (eg. audio system or receiver), turn them on and select the appropriate input source that was used to connect to the DVD player output. Refer to the equipment owner’s manual for detail.
E n g l i s h
Using the Remote Control
●Direct the remote control at the remote sensor of the DVD player.
●Do not drop the remote control.
●Do not leave the remote control near extremely hot or humid place.
●Do not spill water or put anything wet on the remote control.
11