Philips MCD510/21 Preparations, Inserting batteries into the remote control, Setting the clock

Page 21

Preparations

IMPORTANT!

Make sure to complete the preparation procedures before operating the system.

Step 1: Inserting batteries into the remote control

1Open the battery compartment.

2Place two batteries (Type R06 or AA) in the compartment with the correct polarity as indicated by “+” and “–” symbols.

3Close the cover.

Using the remote control to operate the

system

1Point the remote control directly at the remote

sensor (iR) on the front panel.

2Select the source you wish to

control by pressing one of the source select buttons on the remote control (for example TAPE,TUNER).

3 Then select the desired function (for example 2;, í, ë).

CAUTION!

Remove batteries if they are exhausted or will not be used for a long time.

Do not use old and new or different types of batteries in combination.

Batteries contain chemical substances, so they should be disposed of properly.

Step 2: Setting the clock

1In standby mode, press and hold CLOCK SET on the system.

“SET CLOCK” appears.Then, the clock digits for the hours flash.

2Press TUNING S T on the system to set the hours.

3Press CLOCK SET again.

The clock digits for the minutes flash.

4Press TUNING S T on the system to set the minutes.

5Press CLOCK SET to confirm your setting. The system will store the setting automatically. The time setting becomes effective.

Note:

The clock will be cancelled when the power cord is disconnected or if a power failure occurs.

During setting, if no button is pressed within 30 seconds, the system will exit clock setting mode automatically.

English

21

Image 21
Contents DVD Micro Theatre México E a T H R E Windows Media is a trademark of Microsoft Corporation Index EnglishEspañol 111 Contents Tape Operation/Recording Clock/TimerSupplied accessories FeaturesGeneral Information Discs for playbackGeneral Information/Maintenance Care and safety informationEnvironmental information Cleaning the head and the tape paths Cleaning the disc lensFinding a suitable location Demagnetising the headRight ConnectionsLeft Placing speakersConnecting speakers Antennas ConnectionMW Antenna Connecting TV Using an accessory RF modulator English Using S-Video In jackOptional Connecting additional equipment Connecting the power cordConnecting an active subwoofer B Using the VCR for recording DVDs CControls Controls on the system Controls on the remote controlDisc Menu disc mode only System Menu disc mode only$ DBB Dynamic Bass Boost § OKListening through headphones Switching the system onSwitching the system to Eco Power Standby mode Power-saving automatic standbyMicrophone Mixing Basic FunctionsKey Control EchoSetting the clock Inserting batteries into the remote controlUsing the remote control to operate System PreparationsSetting video preference Setting language preferenceConnecting TV To remove the menu Press System MenuTV System TV ShapeVideo Out Pr/Cr Pb/Cb YUsing the disc menu Disc OperationsPlaying discs Basic playback controls English Fast search Programming favorite tracksFor CD/VCD/SVCD Playing MP3/ WMA/picture disc Kodak, Jpeg Special disc featuresJpeg Mixed-mode discSetting language preference Using the system menuSetting video preference DVD only Setting audioSetting Rating English Night Mode turning On / OffOff Use the Numeric Keypad 0-9 to enter the four-digit codeTo change the password To play discs of rating control DVD onlyTo remove the menu Radio Reception Tuning to radio stationsProgramming radio stations Automatic programmingChanging tuning grid not available for Tuning to preset radio stationsTape playback Tape Operation/RecordingRewinding / Fast forwarding General information on recordingWhen recording is in progress Recording timerPreparation for recording Synchro start CD recording for CD onlyClock setting Clock/TimerTimer setting Sleep timer settingSpecifications Troubleshooting ProblemSolution Check that the speakers are connected correctly Glossary