Philips DVD763SA owner manual Specifications, Glossary

Specifications, Glossary 47

Specifications

CABINET

Dimensions (w x h x d):	17.13 x 3.05 x 11.95 inches
	(435 x 77.5 x 303.5 mm)
Weight:	Approximately 6.8 lbs (3.1 kg)
POWER SUPPLY
Power supply	120V, 60 Hz
Power consumption	Approximately 23W
Standby power consumption	<1W
TV STANDARD	PAL/50Hz	NTSC/60Hz
Number of lines	625	525
Playback	Multistandard	(PAL/NTSC)
VIDEO PERFORMANCE
VIDEO OUT	1 Vpp---75Ω
S-VIDEO OUT	Y: 1 Vpp---75Ω; C: 0.3 Vpp---75Ω
Y Pr/Cr Pb/Cb	Y: 1 Vpp---75Ω;
	Pr/Cr and Pb/Cb: 0.7 Vpp---75Ω
AUDIO PERFORMANCE (TYPICAL)
DA Converter	24 bit
Signal to Noise (1kHz)	100dB
Dynamic range (1kHz)	100dB
Crosstalk (1kHz)	105dB
Total Harmonic Distortion (1kHz)97dB
MPEG MP3	MPEG Audio L3
DVD	fs 96 kHz	4 Hz -44 kHz
Video CD/Audio CD	fs 44.1 kHz	4 Hz -20 kHz
Super Video CD	fs 48 kHz	4 Hz -22 kHz
	fs 44.1 kHz	4 Hz -20 kHz

AUDIO FORMAT

Direct Stream Digital/Multichannel/Stereo/MPEG/Compressed Digital

Dolby Digital 16, 20, 24 bits

DTS/PCM	fs 44.1, 48, 96 kHz
MP3	96, 112, 128, 256 kbps and
(ISO 9660)	variable bit rate fs 32, 44.1, 48kHz
SACD AUDIO PERFORMANCE
DA Converter	Direct Stream Digital
Signal to Noise (1kHz)	105dB
Dynamic range (1kHz)	105dB
Crosstalk (1kHz)	105dB
Total Harmonic Distortion (1kHz)97dB
SACD	fs 2.8224 MHz DC 100kHz
Maximum Output Voltage (0dB) 2V rms
Channel unbalance	<0.5 dB
Cut-off frequency	50 kHz (Front)
(Surround/Center/Subwoofer)	40 kHz
REAR CONNECTIONS
Pr/Cr Pb/Cb Y Video Out	Cinch (green/blue/red) 480 interlace
S-Video Out	Mini DIN 4-pins
CVBS Video Out	Cinch (yellow)
Audio Out	Cinch (white/red, left/right)
Digital Audio Out	1 coaxial, 1 optical
	IEC958 for Audio CD and LPCM
	IEC1937 for MPEG1/2/Dolby
	Digital/DTS/Multichannel Audio Out
Front and Surround	Cinch (white/red, left/right)
Center	Cinch (blue)
Subwoofer (Subwf)	Cinch (black)
LASER
Type	Semiconductor laser GaAIAs
Wavelength	650nm (DVD)
	780nm (Video CD/Audio CD)
Output power	7mW (DVD)
	10mW (Video CD/Audio CD)
Beam divergence	60 degree

Glossary

Analog: Analog sound is available when you use the red and white audio jacks on your equipment. These jacks send audio through two channels, the left and right.

AUDIO OUT Jacks: Jacks on the Player that send audio to another system (TV, Stereo, Receiver, etc.).

Bit Rate: The amount of data used to hold music; measured in kilobits per seconds, or kbps. Or, the speed at which you record. Generally, the higher the bit rate, or the higher the recording speed, the better the sound quality. Higher bit rates use more Disc space.

Coaxial jack: Sends digital audio to a Stereo, allowing you to adjust the volume at the Stereo. The Stereo must have a coaxial in jack. This connection provides the 5.1 channel surround sound.

Component Video Out Jacks: Jacks on the back of the Player that send high-quality video to a TV that has Component Video In jacks.

Digital: Sound that has been converted into numerical values. Digital sound is available when you use the Coaxial or Optical Digital Audio Out jacks. These jacks send audio through multiple channels, instead of just two channels as analog does.

Direct Stream Digital (DSD): Technology used to record SACDs. DSD uses a 1-bit system with a digital sampling frequency 64 times higher than a regular Audio CD, creating a frequency response of over 50 kHz and a 120 dB dynamic range.

Dolby Digital: A surround sound system that provides 5.1 channel sound.

DTS: Digital Theater Systems. This is a surround sound system, but it is different from Dolby Digital. The formats were devel- oped by different companies.

Letterbox: A TV aspect ratio setting (4:3). Displays the video in full-width, with black bars at the top and bottom of the TV screen. This format is similar to seeing a movie in a theater.

OPTICAL Jack: Converts electrical signals into optical signals before sending the audio to the Stereo. Optical audio is not prone to external electrical influences and has less noise. Keep the protective cap on the jack when it is not in use; this keeps dust out of the jack.

Pan & Scan: A TV aspect ratio setting (4:3). Displays the video with full-height picture, with one or both sides of the picture trimmed. Some movie companies refer to this as “reformatting the picture to fit your TV screen.”

S-Video: Produces a clearer picture by sending separate signals for the luminance and the color. If you connect the supplied S- Video cable, you will not need to use the supplied yellow video cable. You can use S-Video only if your TV has an S-Video In jack.

VIDEO OUT Jack: Jack on the back of the Player that sends video to a TV.

Widescreen: A TV aspect ratio setting (16:9). Displays the video appropriately when you connect the Player to a widescreen TV.