Philips DVDQ50 owner manual Receiver Example onlyBack of TV example only

Hookups (cont’d) 15

Connecting to a TV and to a Six-channel Receiver (Dolby Digital & DTS)

Receiver

(example only)Back of TV (example only)

5

MAINS

	MULTICHANNEL AUDIO IN
	SURROUND SUB WF	FRONT	S-Video In
	R
	L		1
	CENTER	FRONT
4	2		3
		FRONT
DIGITAL AUDIO OUT			1
PCM/MPEG2/AC-3/DTS

R R 2

COAXIAL	OPTICAL	SURROUND SUB WF FRONT	AUDIO CVBS	Pr/Cr	Pb/Cb	Y	S-VIDEO	Pr/Cr Pb/Cb	Y
		MULTICHANNEL AUDIO OUT	OUT		VIDEO OUT			PROGRESSIVE SCAN OUT

1

Connect the supplied S-Video cable to the S-VIDEO OUT jack of the DVD Player and to the TV’s S-VIDEO IN jack. Or, use the DVD Player’s CVBS VIDEO OUT jack or Component VIDEO OUT jacks to connect to the TV. Details are on pages 10 and 12. You only need one video connection.

2

Connect the CENTER jack on the DVD Player to the CENTER IN jack on your Receiver. Connect the SUB WF. jack of the DVD Player to the SUBWOOFER IN jack on your Receiver.

3

Connect the FRONT Left and Right OUT jacks of the DVD Player to the FRONT Left and Right IN jacks on your Receiver.

4

Connect the SURROUND Left and Right OUT jacks of the DVD Player to the SURROUND Left and Right IN jacks on your Receiver. Your Receiver may refer to Surround as Rear. These are the same.

5

Connect the flat end of the DVD Player’s power cord (supplied) to the MAINS (AC Power) jack on the back of the DVD Player. Connect the power cords of the DVD Player, TV, and Receiver to the power outlet. Turn on the power of the TV and the Receiver. Press STANDBY-ON on the DVD Player to turn on the DVD Player. The Standby light will disappear.

6

Set the TV to the correct Video In channel. Refer to your TV manual. Or, change TV channels until you see the DVD logo on the TV. Set your Receiver to the correct Audio In channel or sound source. Refer to the Receiver’s manual.

7

Set Analog output to Multi-channel, then adjust the Speaker settings. Details are on pages 48- 49.