Philips DVP3030A/94 user manual Getting Started, Inserting batteries into the Remote Control

Page 12

Getting Started

Step 1: Inserting batteries into the Remote Control

1 2

CR 2025

L

I

THIUM

1Pull out the plastic protective sheet.

2To replace battery (Lithium CR2025);

pull out the battery compartment

replace a new battery and fully insert the battery compartment back to the original position.

3Close the cover.

Using the Remote Control to operate the Player

1Aim the Remote Control directly at the remote

STOP PLAY/PAUSE

sensor (iR) on the front panel.

2Do not put any objects between the Remote Control and the DVD Player while operating the DVD Player.

CAUTION!

Remove batteries if they are exhausted or if the Remote Control is not being used for a long time.

Batteries contain chemical substances, so they should be disposed properly.

12

Step 2: Setting up the TV

IMPORTANT!

Make sure you have completed all the necessary connections. (See page 6-7 “Connecting TV”).

1Turn on the TV and set to the correct video-in channel. You should see the DVD background screen on the TV.

2Usually these channels are between the lowest and highest channels and may be called FRONT,A/V IN, or VIDEO. See your TV manual for more details.

Or, you may go to channel 1 on your TV, then press the Channel down button repeatedly until you see the Video In channel.

Or, the TV Remote Control may have a button or switch that chooses different video modes.

Or, set the TV to channel 3 or 4 if you are using an RF modulator.

3If you are using external equipment, (eg. audio system or receiver), turn it on and select the appropriate input source for the DVD Player output. Refer to the equipment owner’s manual for detail.

To deactivate Progressive manually

When the distorted picture still appears on the TV, it may be due to the connected TV does not accept progressive signals, and progressive is set by mistake. You must reset the unit to interlace format.

1Turn off your TV progressive scan mode or turn on to interlaced mode (refer to your TV user manual.)

2Press OPEN/CLOSE on the DVD player to open the disc tray.

3Press numeric keypad ‘1’ on the

remote control for few seconds.

The DVD blue background screen will appear on the TV.

3139 246 15972

Image 12
Contents DVD Video Player Laser safety General InformationEnvironmental Information LaserPage Contents Supplied accessories Care and safety informationIntroduction Using Composite Video jacks Cvbs Using S-Video jackConnections Using Component Video jacks Y Pb Pr Using an accessory RF modulatorConnecting the adaptor Optional Connecting speakers Optional Connecting to an Audio System Optional Connecting Digital AV Receiver Receiver has a PCM, Dolby Digital, or MPEG2 decoder Functional Overview Front and Rear PanelsRemote Control Inserting batteries into the Remote Control Setting up the TVUsing the Remote Control to operate the Player Getting StartedSetting the TV Display Selecting the color system that corresponds to your TVPress System Menu Setting language preference Setting the OSD LanguageSetting the Audio, Subtitle and DVD menu language Press 2 to select LANGUAGE, then press OKDisc Operations Playable DiscsRegion Codes Your DVD Player will playPower Resume Using the Disc MenuPlaying discs Basic playback controls Play BSlow Motion DVD/VCD Forward / Reverse Searching DVD/VCD/CDPreview DVD/VCD For DVDSpecial DVD features Playing MP3/JPEG Picture CDPlayback selection RepeatZoom picture Jpeg Playback with multi-angles JpegDVD Setup Menu Options Video SetupLanguage Setting the Video Output VideoProgressive turning on/off OFFAudio Setup Digital OutputALL PCMNight Mode turning on/off Lpcm Output48kHz Playback a disc recorded at the sampling rate of 48kHzChanging the Password RatingSetting the Rating Restoring to original settingsRating explanations Specifications Audio FormatTroubleshooting Problem SolutionButtons do not work Glossary Page Meet Philips at the Internet 3139 246 Sgp-SL-0533/94-2