4 Get started
Prepare the remote control
1Press and push the battery compartment to slide it open (see “1” in the illustration).
2Insert two AAA batteries with correct polarity
3Push and slide back the battery compartment (see “3” in the illustration).
Note
•If you are not going to use the remote control for a long time, remove the batteries.
•Do not mix batteries (old and new or carbon and alkaline, etc.).
•Batteries contain chemical substances, so they should be disposed of properly.
Find the TV input channel
1Press to turn on this product.
2Turn on the TV and switch to the video input channel (refer to the TV user manual on how to select the A/V input channel).
Select menu display language
1Press SETUP.
» [General Setup] menu is displayed.
2Select [OSD Language], and then press .
3Press to select a language, and then press OK.
Turn on progressive scan
Note
•To use the progressive scan feature, you must connect a progressive scan TV with the component video jacks (see “Connect” > “Connect audio/video cables” > “Option 1: Connect to the component video jacks” for details).
1Turn on the TV to the correct video input channel for this product.
2Press SETUP.
3Press to select [Video Setup].
4Select [Progressive] > [On], and then press
OK.
» A warning message is displayed.
5To proceed, select [Ok] and then press OK. » The progressive setup is complete.
Note
•If a blank/distorted screen is displayed, wait for 15 seconds for the auto recovery.
•If no picture is displayed, turn off the progressive scan mode as follows:
1)Press to open the disc compartment.
2)Press the Numeric button ‘1’.
6Press SETUP to exit the menu.
7You can now turn on the progressive scan mode on the TV (see the TV user manual).
Note
•During play, when the progressive scan mode is on for both this product and the TV, distorted picture may display. In this case, turn off the progressive scan feature on both this product and the TV.
8EN