Philips DVP533K/78 manual Getting Started, Inserting batteries into the Remote Control

PREVIEW MUTE

Getting Started

E n g l i s h

Step 1: Inserting batteries into the Remote Control

3

1

2

1Open the battery compartment.

2Insert two batteries type R06 or AA, following the indications (+-) inside the compartment.

3Close the cover.

Using the Remote Control to operate the Player

1Aim the Remote Control

Step 2: Setting up the TV

IMPORTANT!

Make sure you have completed all the necessary connections. (See pages 8-9 “Connecting TV”).

1 Turn on the TV and set to the correct

video-in channel. You should see the blue

Philips DVD background screen on the

TV.

➜ Usually these channels are between the

lowest and highest channels and may be

called FRONT,A/V IN, or VIDEO. See your

TV manual for more details.

➜ Or, you may go to channel 1 on your

TV, then press the Channel down button

repeatedly until you see the Video In

channel.

➜ Or, the TV Remote Control may have a

button or switch that chooses different

directly at the remote sensor (iR) on the front panel.

2Do not put any objects

STOP

video modes.

➜ Or, set the TV to channel 3 or 4 if you

are using an RF modulator.

2 If you are using external equipment, (eg.

between the Remote Control and the DVD Player while operating the DVD Player.

CAUTION!

–Remove batteries if they are exhausted or if the Remote Control is not being used for a long time.

–Do not use old and new or different types of batteries in combination.

–Batteries contain chemical substances, so they should be disposed properly.

audio system or receiver), turn it on and

select the appropriate input source for

the DVD Player output. Refer to the

equipment owner’s manual for detail.

14

01-34 DVP533K_78	14	8239 300 32131
		19/03/2004, 2:55 PM