Philips DVP3326X Get started, Prepare the remote control, Find the correct viewing channel

Page 11

4 Get started

Prepare the remote control

1Open the battery compartment.

2Insert two R03 or AAA batteries with correct polarity (+/-) as indicated.

3Close the battery compartment.

Caution

Remove batteries if they are exhausted or if the remote control is not to be used for a long time.

Do not mix batteries (old and new or carbon and alkaline, etc.).

Batteries contain chemical substances, so they should be disposed of properly.

Find the correct viewing channel

1Press to turn on this product.

2Turn on the TV and switch to the correct video-in channel. (Refer to the TV user manual on how to select the correct channel.)

Select menu display language

General Setup

Disc Lock

English

OSD Language

 

Sleep Timer

 

Auto Standby

 

The language options may vary from different regions.

1 Press SETUP.

» [General Setup] menu is displayed.

2Select [OSD Language], then press.

3Press to select a language, then press OK.

Turn on progressive scan

Note

To use the progressive scan feature, you must connect a progressive scan TV with the component video jacks (see “Connect” > “Connect video cables” > “Option 1: Connect to the component video jacks” for details).

Video Setup

 

TV System

 

 

 

 

 

 

 

 

 

On

 

 

TV Display

 

 

 

Off

 

 

Progressive

 

 

 

 

 

 

Picture Setting

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

12EN

Image 11
Contents Register your product and get support at Contents About Progressive Scan Safety and important noticeDisposal of your old product and batteries Copyright notice Trademark noticeRegion codes Feature highlightsProduct overview Main unitStop play Start, pause or resume disc play Remote controlZoom the picture in or out Volume Info Option 2 Connect to video Cvbs jack ConnectConnect video cables Option 1 Connect to component video jacksConnect to digital ampli er/receiver Connect audio cablesRoute audio to other devices Connect multi channel receiverConnect a USB ash drive to the jack on this product Connect powerConnect USB device Connect analogue stereo systemSelect menu display language Prepare the remote controlGet started Find the correct viewing channelPress Setup to exit the menu Control video play PlayPlay a disc Play videoSkip play to a speci c time Access DVD menuAccessVCD menu Preview disc contentsPlay photo Play musicPlay musical slideshow Play from USB deviceControl photo play To exit the menu, select Exit, then press OK Create MP3 lesSpeed Select a copying speed Bitrate Select a quality level Select Start in the menu, then press OK to start to convertOff Disable the auto standby mode Adjust settingsGeneral setup Audio setupSmall Signal below 120 HzLarge Below 120 HzPicture Setting Video setupTo exit the menu, press Setup TV System PBC PreferencesVersion Info Display the software version of this product DefaultCare Update softwareAdditional information USB Specifications26 EN Play TroubleshootingPicture SoundAspect ratio GlossaryLanguage Code GSM / WLL