[Analogue Output]
Select an analogue setting based on the audio device that is connected through the analogue audio jack.
•[Stereo] - For stereo output.
•[LT/RT] - For surround sound output through two speakers.
[Digital Audio]
Select a digital setting based on the digital ampli er/receiver that is connected through the digital jack (coaxial/digital).
•[Digital Output] - Select a type of digital output.
•[Off] - Disable digital output.
•[All] - Support
•[PCM Only] - Downmix to two- channel audio format.
•[LPCM Output] - Select the LPCM (Linear Pulse Code Modulation) output sampling rate.
•[48kHz] - For discs recorded at sampling rate of 48 kHz.
•[96kHz] - For discs recorded at sampling rate of 96 kHz.
Note
•[LPCM Output] setting is only available if the [Digital Output] is set to [PCM Only].
•The higher the sampling rate, the better the sound quality.
[Volume]
Set the default volume level when you play a disc.
1. Press OK.
2. Press 
to set the volume.
3. Press OK to con rm and exit.
[Sound Mode]
Select a preset sound effect to enhance the audio output.
•[3D] - Select a virtual surround sound effect that is produced from the left and right audio channels.
•[Movie Mode] - Select a sound effect for movies.
•[Music Mode] - Select a sound effect for music.
[Speaker Setup]
Optimizes surround output for the connected speakers system.
•[Front Speaker]
Option Description
[Large] Produces low frequency signal below 120 Hz.
[Small] Cannot produce low frequency signal below 120 Hz.
•[Centre Speaker] / [Rear Speaker]
Option | Description |
[Large] | Produces low frequency signal |
| below 120 Hz. |
[Small] | Cannot produce low frequency |
| signal below 120 Hz. |
[Off] | No speaker is connected. |
•[Subwoofer]
Option | Description |
[On] | A subwoofer is connected. |
[Off] | No subwoofer is connected. |
•[SpeakersVolume] – Sets the volume level of each speaker to get the ideal audio balance.
Press OK.
Select a speaker, then press 
to adjust the volume.
Press OK to con rm and exit.
•[Speakers Delay] – Sets the delay time for the center and rear speakers if they are placed closer to the listening position, so that the sound output from all speakers reach the listening position at the same time.
20EN