Philips DVP3111 user manual Audio setup

Page 13

[OSD Language]

Select an on-screen menu language. [Sleep Timer]

Switch automatically to standby at the preset time.

[Off] - Disable sleep mode.

[15 mins], [30 mins], [45 mins], [60 mins] -Select the count down time for this product to switch to standby.

[Auto Standby]

Turn on or off automatically standby.

[On] - Switch to standby 15 minutes of inactivity (for example, in pause or stop mode).

[Off] - Disable the auto standby mode. [DivX(R) VOD Code]

Display the DivX® registration code.

Tip

Use this player’s DivX registration code when you rent or purchase video from www.divx.com/vod. The DivX videos rented or purchased through the DivX® VOD (Video On Demand) service can be played only on the device to which it is registered.

Audio setup

1Press SETUP.

» [General Setup] menu is displayed.

2Press to select [Audio Setup], then press .

3Select an option, then press OK.

4Select a setting, then press OK.

To return to the previous menu, press .

To exit the menu, press SETUP. [Analogue Output]

Select an analogue setting based on the audio device that is connected through the analogue audio jack.

[Stereo] - For stereo output.

[LT/RT] - For surround sound output through two speakers.

[Digital Audio]

Select a digital setting based on the digital amplifier/ receiver that is connected through the digital jack (coaxial/digital).

[Digital Output] - Select a type of digital output.

[Off] - Disable digital output.

[All] - Support multi-channel audio formats.

[PCM Only] - Downmix to two-channel audio format.

[LPCM Output] - Select the LPCM (Linear Pulse Code Modulation) output sampling rate.

[48kHz] - For discs recorded at sampling rate of 48 kHz.

[96kHz] - For discs recorded at sampling rate of 96 kHz.

Note

[LPCM Output] setting is only available if the [Digital Output] is set to [PCM Only].

The higher the sampling rate, the better the sound quality.

[Volume]

Set the default volume level when you play a disc.

1.Press OK.

2.Press to set the volume.

3.Press OK to confirm and exit.

[Sound Mode]

Select a preset sound effect to enhance the audio output.

[3D] - Select a virtual surround sound effect that is produced from the left and right audio channels.

[Movie Mode] - Select a sound effect for movies.

[Music Mode] - Select a sound effect for

music.

[Night Mode]

Make loud sound level softer and soft sound level louder so that you can watch the DVD movies at a low volume, without disturbing others.

[On] – Enjoy quiet viewing at night.

[Off] – Enjoy surround sound with a full dynamic range.

Note

Applicable only to Dolby Digital encoded DVD.

English

EN 13

Image 13
Contents Register your product and get support at DVP3111 Page Contents Trademark notice Safety and important noticeAbout Progressive Scan Disposal of your old product and batteriesMain unit Remote control Feature highlightsYour DVD player Product overviewConnect video cables ConnectOption 2 Connect to video Cvbs jack for a standard TV Route audio to other devices Connect audio cablesGet started Play Access DVD menuPlay a disc Play videoPreview disc contents AccessVCD menuSkip play to a specific time Display play timeQuick skip play Play photoPlay MP3/WMA music Play photo as slideshowGeneral setup Adjust settingsPlay musical slideshow 12 ENAudio setup Preferences Video setup14 EN Version Info Display the software version of this product Hebrew except for Australia and New Zealand HebrewAdditional information Clean discsCare SpecificationsMain unit TroubleshootingPicture SoundAspect ratio GlossaryProgressive scan ¡ESKY Language CodeKoninklijke Philips Electronics N.V All rights reserved