4 Get started
Prepare the remote control
1Open the battery compartment.
2Insert two R03 or AAA batteries with correct polarity
3Close the battery compartment.
Caution
Remove batteries if they are exhausted or if the remote control is not to be used for a long time.
Do not mix batteries (old and new or carbon and alkaline, etc.).
Batteries contain chemical substances, so they should be disposed of properly.
Find the correct viewing channel
1Press 
to turn on this product.
2Turn on the TV and switch to the correct
Select menu display language
The language options may vary from different regions.
1Press SETUP.
» [General Setup] menu is displayed.
2Select [OSD language], then press 
.
3 Press 
to select a language, then press OK.
Turn on progressive scan
Note
To use the progressive scan feature, you must connect a progressive scan TV with the component video jacks (see “Connect” > “Connect video cables” > “Option 1: Connect to the component video jacks” for details).
1Turn on the TV to the correct viewing channel for this product.
2Press SETUP.
3Press 
to select [Video Setup].
4Select [Progressive] > [On], then press OK. » A warning message is displayed.
5To proceed, select [Ok] and press OK. » The progressive setup is complete.
Note
If a blank/distorted screen is displayed, wait for 15 seconds for the auto recovery.
If no picture is displayed, turn off the progressive scan mode as follows:
1)Press 
to open the disc compartment.
2)Press the Numeric button ‘1’.
6Press SETUP to exit the menu.
7You can now turn on the progressive scan mode on the TV (see the TV user manual).
Note
During play, when the progressive scan mode is on for both this product and the TV, distorted picture may display. In this case, turn off the progressive scan feature on both this product and the TV.
8EN