Audio Setup Menu, Setting the Downmix, Stereo

General Audio

E n g l i s h

Audio Setup Menu

1In disc mode, press SETUP.

2Press 1 2 to select ‘Audio Setup’.

3Press OK to confirm.

Video Preference

- - Speaker Setup Page - -

Downmix

Digital Audio

This options allows you to set the stereo analog output of your DVD Player.

1In ‘AUDIO SETUP PAGE’, press 3 4 to highlight {DOWNMIX}, then press 2.

Select this to change channel output to stereo which delivers sound from only the two front speakers.

Select this option if your DVD Player is connected to a Dolby Pro-Logic decoder.

2Press 3 4 to select a setting, then press OK to confirm your selection.

The options included in Digital Audio Setup are:‘Digital Output’ and ‘LPCM Output’.

1In ‘AUDIO SETUP PAGE’, press 3 4 to highlight {DIGITAL AUDIO}, then press 2.

2Press the 3 4 keys to highlight an option.

3Enter its submenu by pressing 2.

4Press 3 4 to select a setting, then press OK to confirm your selection.

Set the Digital output according to your optional audio equipment connection.

➜SPDIF Off:Turn off the digital output.

➜All: If you have connected your DIGITAL AUDIO OUT to a multi-channel decoder/receiver.

➜PCM Only: Only if your receiver is not capable of decoding multi-channel audio.

–If DIGITAL OUTPUT is set to ‘All’, all audio settings except MUTE are invalid.

If you connect the DVD Player to a PCM compatible receiver via the digital terminals, such as coaxial or optical etc, you may need to adjust ‘LPCM’.

Discs are recorded at a certain sampling rate.The higher the sampling rate, the better the sound quality.

➜48kHz: Playback a disc recorded at the sampling rate of 48kHz.

➜96kHz: Playback a disc recorded at the sampling rate of 96kHz.

TIPS: The underlined option is the factory default setting.

Press 1 to go back to the previous menu item. Press SETUP to exit the menu item.

01-35_DVP3020_55_Eng_RC2

28/06/06, 1:25 PM