Philips DVD701/931 specifications Connecting the power cord, Remote control battery installation

				Connecting to an A/V receiver equipped with a multi-
AMPLIFIER				channel decoder (Dolby Digital™(AC-3), MPEG 2 and
				DTS)
				Digital Multi-channel sound
			TV	Digital multi-channel connection provides the best sound quality. For this you
				need a multi-channel A/V receiver that supports one or more of the audio
				formats supported by your DVD player (MPEG 2, Dolby Digital™(AC-3),
				AC3 and DTS). Check the receiver manual and the logos on the front of the
				receiver.
F	E			1 Connect the DVD player’s digital audio output to the corresponding
				input on the receiver using an optional digital audio cable.
				2 You will need to activate the player’s digital output (see ‘Personal
				Preferences’).
				Note:
				If the audio format of the digital output does not match the capabilities of your
				receiver, the receiver will produce a strong, distorted sound or no sound at all.The
				selected audio format of the DVD is displayed in the Status Window when the
				Menu OSD is activated or Audio button is activated.
	DIGITAL AUDIO OUT	STEREO OUT	IN	Six Channel Digital Surround Sound via digital connection can only be obtained if
			I
			AUX/VCR
	PCM/MPEG2/AC3/DTS			your receiver is equipped with a Digital Multi-channel decoder.
			TV OUT
			II
MAINS				To see the selected audio format of the current DVD in the Status Window, press
		R L	(CVBS)
	DIG OUT	AUDIO OUT	VIDEO OUT
				the MENU OSD or the Audio Language selector button.

- + - +

Connecting the power cord

1Plug the female end of the supplied power cord into the Mains (AC) jack on the rear of the player.

2Connect the other end of the cord to an AC outlet.

Note: When the player is in the “STANDBY” mode, it is still consuming some power. If you wish to disconnect your player completely from the power, unplug the power cord from the AC outlet.

Caution: Only qualified service personnel should remove the cover or attempt to service this device.

Remote control battery installation

Loading the batteries

1Open the battery compartment cover.

2Insert batteries as indicated inside the battery compartment.

3Close the cover.

Caution: Do not mix old and new batteries. Never mix different types of batteries (standard, alkaline, etc.).

PREPARATION 15