Get started, Prepare the remote control

4 Get started

Caution

•Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation.

Always follow the instructions in this chapter in sequence.

If you contact Philips, you will be asked for the model and serial number of this apparatus.The model number and serial number are on the bottom of the apparatus.Write the numbers here:

Model No. __________________________

Serial No. ___________________________

Prepare the remote control

Caution

•Risk of explosion! Keep batteries away from heat, sunshine or ﬁ re. Never discard batteries in ﬁ re.

For ﬁ rst-time use:

1Remove the protective tab to activate the

remote control battery.

To replace the remote control batteries:

1Open the battery compartment.

2Insert one lithium CR2025 battery with correct polarity (+/-) as indicated.

3Close the battery compartment.

Note

•Before you press any function button on the remote control, ﬁ rst select the correct source with the remote control.

•If you are not going to use the remote control for a long time, remove the battery.

Set clock

1	In the standby mode, press and hold	English

CLOCK to activate the clock setting mode.

» The hour digits are displayed and begin to blink.

2Press +VOL - to set the hour.

»The minute digits are displayed and begin to blink.

3Press +VOL - to set the minute.

4Press CLOCK to conﬁ rm the clock setting.

Turn on

1 Press .

»The unit switches to the last selected source.

Switch to standby mode

1 Press again.

»The clock (if set) appears on the display panel.

Find the correct viewing channel

1 Press to turn on the unit.

2Press DISC to switch to disc mode.

3Turn on the TV and switch to the correct video-in channel in one of the following ways:

•Go to the lowest channel on your TV, then press the Channel Down button until you see the Philips screen.

•Press the source button repeatedly on the remote control of your TV.

EN 15