Philips MCD139B/55 user manual Connections, Placing speakers Connecting speakers Subwoofer

English

Connections

Step 1: Placing speakers and		Step 2: Connecting speakers
	subwoofer		and subwoofer

For best possible surround sound, locate your speakers and subwoofer as follows:

●Place the left and right speakers at equal distances from the TV set and at an angle of approximately 45 degrees from the listening position.

●Place the subwoofer on the floor.

Notes:

–To avoid magnetic interference, position the speakers, subwoofer as far as possible from the main unit,TV set or other radiation source.

–Allow adequate ventilation around the DVD System.

IMPORTANT!

The type plate is located on the bottom of the system.

To avoid overheating of the system, a safety circuit has been built in. Therefore, your system may switch to Standby mode automatically under extreme conditions. If this happens, let the system cool down before reusing it.

●Connect the supplied DIN cable to DVD playerÕs DIN jack and the left speakerÕs DIN jack.

●Connect the supplied speaker wires of the right speaker to SPEAKER RIGHT on the left speaker, red wire to red jack ( Ò+Ó ), black wire to black jack ( Ò-Ò ). Fully insert the stripped portion of the speaker wire into the terminal as shown.

●Connect the supplied speaker wire of the subwoofer to SUBWOOFER OUT on the left speaker, green wire to green jack ( Ò+Ó ), white wire to white jack ( Ò-Ó ).

Notes:

–For optimal sound performance, use the supplied speakers.

–Do not connect more than one speaker to any one pair of +/- speaker terminals.

–Do not connect speakers with an impedance lower than the speakers supplied. Please refer to the SPECIFICATIONS section of this manual.

10