17
1
2 CR2025
3
CAUTION!
Batteries contain chemical substances, so they should be disposed of properly.
Pull out the battery compartment.
Press the slot on the battery compartment.
1
2
3 Replace a new battery and fully insert the battery compartment back to the original position.
Remove the plastic protective sheet
Replacing battery (lithium CR2025) into the remote control
5 Press VOLUME +/- on the front panel or VOL +/- on the remote to set the minutes.
6 Press DISPLAY/CLOCK to confirm the clock setting.
Notes:
– The clock setting will be erased when the system is disconnected from the power supply.
– The system will exit clock setting mode if no button is pressed within 20 seconds.
3 Then select the desired function (for example ÉÅ , à, á).
3 Press VOLUME +/- on the front panel or VOL +/- on the remote to set the hours.
4 Press DISPLAY/CLOCK again.
➜ The minute digits flash on the display screen.
the system.
Before using the remote control
1 Pull out the plastic protective sheet.
2 Select the source you wish to control by pressing one of the source select keys on the remote control (for example DISC,TUNER).
1 Go to Standby mode.
2 Press and hold DISPLAY/CLOCK on the remote control.
➜ "SET CLOCK" is displayed briefly.Then, the hour digits flash on the display screen.
– Make sure to complete the preparation procedures before operating
Step 2: Setting the clock
IMPORTANT!
Preparations