Troubleshooting
En gli sh
Problem
The DVD player does not start playback.
There is no sound from the center and rear speakers.
Radio reception is poor.
The remote control does not function properly.
The TV screen has no display when progressive scan function is activated.
Solution
–Insert a readable disc with the playback side facing down. The
–Check the disc type, colour system and region code.
–Check for any scratches or smudges on the disc.
–Press SYSTEM SETUP to turn off the setup menu screen.
–You may need to enter the password in order to change the parental control rating level or to unlock the disc for playback.
–Moisture has condensed inside the system. Remove the disc and leave the system turned on for about an hour.
–Press CENTER +- or REAR +- to adjust the volume level.
–Make sure the center and rear speakers are connected correctly.
–Press SURROUND button to select a correct surround sound setting.
–Make sure the source you are playing is recorded or broadcast in surround sound (DPL II, Dolby Digital, etc.)
–If the signal is too weak, adjust the antenna or connect an external antenna for better reception.
–Increase the distance between the system and your TV or VCR.
–Tune in to the correct frequency.
–Place the antenna farther away from any equipment that may be causing the noise.
–Select the source (DISC or TUNER, for
example) before pressing the function button (ÉÅ, S, T).
–Reduce the distance between the remote control and the system.
–Replace the batteries with new ones.
–Point the remote control directly toward the IR sensor.
–Check that the batteries are loaded correctly.
–Ensure that you have activated the progressive scan function.To activate, reder to your TV user manual.
–Ensure that your TV supports progressive scan, if not see page 18 to deactivate it.
–Ensure that your cables are connected correctly, See page 8 for propor connections.
34