Philips HTS3019/12 First time tuning, Listen to radio, Reinstall all the radio stations

Tip

•For better FM stereo reception, connect an external FM antenna (not supplied).

•Position the antenna as far away as possible from your TV, VCR or other radiation source to prevent interference.

First time tuning

When you access radio mode for the first time, follow the instructions to install the radio stations.

1 Press RADIO.

»‘AUTO INSTALL ... PRESS PLAY’ is displayed.

2 Press .

»All detected radio stations are stored.

»Once complete, it tunes to the first preset radio station.

•To stop auto tuning, press .

Note

•This Home Theatre System can store up to a maximum of 40 radio stations.

•If auto installation is not activated or less than 5 radio stations are stored, you will be prompted to install the radio stations again.

Listen to radio

1 Press RADIO.

2 Use the remote control to control the radio.

Button Action

Selects a preset radio station.

Tunes the radio frequency up or down.

Press and hold this button to erase the current radio station from the preset list.

The preset number for other radio stations remain unchanged.

Reinstall all the radio stations

1 Press RADIO.

2 Press and hold PROGRAM for more than

5 seconds.

»All previously stored radio stations are replaced.

Note

•Check the radio antenna connection if no stereo signal is detected or less than 5 stations are detected during radio installation.

Search and store radio stations individually

1 Press RADIO.

2 Press / .

»It starts searching until a radio station is detected.

3 Repeat step 2 until you tune to the radio station you wish to store.

•To finetune the radio frequency, press / .

4 Press PROGRAM.

»The preset station number blinks.

»If no action is carried out within 20 seconds after the above step, it exits the preset mode.

5 Press / (or the Numeric buttons) to select a preset number to store.

6 Press PROGRAM to confirm.

22EN