18 Playing a Disc
DVD AUDIO CD
Playing a DVD or an Audio CD
Before you begin...
Turn on the power of the TV, amplifier and any other equipment connected to the DVD Player. Make sure the TV and the stereo or amplifier (if applicable) are set to the correct channel. Details are on pages
1
Press the POWER button to turn on the DVD Player. “HELLO” will appear briefly on the display panel.
3Insert a Disc.
1 | TITLEPOWER |
| OPEN/ | 2 |
MENU | CLOSERETURN | |||
| ENTER |
| STOP | 5 |
2
Press the OPEN/CLOSE button to open the Disc tray.
3
Place a Disc into the tray. Make sure the Disc is sitting prop- erly in the correct recess.
REV
4
1
4
7
CLEAR
SETUP
PLAY | FWD |
2 3
5 6
8 9
0+10
MODE DISPLAY
Some DVDs are recorded on both sides. Make sure the side you want to play is facing up. Or, if the DVD is recorded on only one side, place the Disc in the tray with the label facing up.
4
Press the PLAY button. The tray will close automatically, and playback will begin at the first Chapter or Track of the Disc. Or, you may press the OPEN/CLOSE button to close the tray, and DVD playback will start automatically. (You also may close the tray by gently pressing the Disc tray toward the DVD Player.)
If the DVD in the tray has a menu, the menu may appear on the screen instead. Details are on page 19.
With some Audio CDs, playback will not begin until you press the PLAY button.
5
Press the STOP button to stop playback.
Remember, this DVD Player will play only certain Discs.
See page six for details.
| PAUSE/STILL | REPEAT |
SKIP | SEARCH MODE | |
AUDIO | SUB TITLE | ANGLE |
Helpful Hints
•A “No Feature” symbol may appear at the bottom right of the TV screen. This symbol means either the feature you tried is not available on the Disc, or the DVD Player can not access the feature at this time. This does not indicate a problem with the DVD Player.
•If a Disc is dirty or has scratches, the pictures may appear distorted and playback may stop. In such cases, remove the Disc and turn off the DVD Player. Disconnect the power cord, then reconnect it. Clean the Disc, then turn on the DVD Player again and reinsert the Disc for play- back.
•When the DVD or CD light appears on the display panel, the Disc is loaded completely and is ready for playback.