Enhancing your system, Troubleshooting chart

Enhancing your system

The connection cord is not included. Purchase a commercially available cord as shown below.

Portable audio player, etc.

Audio cable (not supplied)

MICRO COMPONENT S Y S TEM

Listening to the playback sounds of portable audio player, etc.

1Use a connection cord to connect the portable audio player etc. to the AUDIO IN jack. When using video equipment, connect the audio output to this unit and the video output to a television.

2Press the ON/STAND-BY button to turn the power on.

3Press the AUDIO IN button on the remote control or FUNCTION button repeatedly on main unit to select AUDIO IN function.

4Play the connected equipment. If volume level of the connected device is too high, sound distortion may occur. Should this happen, lower the volume of the connected device. If volume level is too low, increase the volume of the connected device.

Note:

To prevent noise interference, place the unit away from the television.

Headphones

●Do not turn the volume on to full at switch on and listen to music at moderate levels. Excessive sound pressure from earphones and headphones can cause hearing loss.

●Before plugging in or unplugging the headphones, reduce the volume.

●Be sure your headphones have a 1/8" (3.5 mm) diameter plug and impedance between 16 and 50 ohms. The recommended impedance is 32 ohms.

●Plugging in the headphones disconnects the speakers automatically. Adjust the volume using the VOLUME control.

Troubleshooting chart

Many potential problems can be resolved by the owner without calling a service technician.

If something is wrong with this product, check the following before calling your authorized SHARP dealer or service center.

General

Symptom	Possible cause

● The clock is not set	● Did a power failure occur?
to the correct time.	Reset the clock. (Refer
	page 10)

● When a button is	● Set the unit to the power
pressed, the unit	stand-by mode and then
does not respond.	turn it back on.
	● If the unit still malfunctions,
	reset it. (Refer page 14)

● No sound is heard.	● Is the volume level set to
	“0”?
	● Are the headphones
	connected?
	● Are the speaker wires
	disconnected?

CD player

Symptom	Possible cause

● Playback does not	● Is the disc loaded upside
start.	down?
● Playback stops in	● Does the disc satisfy the
the middle or is not	standards?
performed properly.	● Is the disc distorted or
	scratched?

● Playback sounds are	● Is the unit located near
skipped, or stopped	excessive vibrations?
in the middle of a	● Is the disc very dirty?
track.	● Has condensation formed
	inside the unit?

Remote control

Symptom	Possible cause

● The remote control	● Is the AC power cord of the
does not operate.	unit plugged in?
	● Is the battery polarity
	correct?
	● Are the batteries dead?
	● Is the distance or angle
	incorrect?
	● Does the remote control
	sensor receive strong
	light?

Tuner

Symptom

Possible cause

●The radio makes ● Is the unit placed near the

unusual noises	TV or computer?
continuously.	● Is the FM antenna or AM
	loop antenna placed
	properly? Move the
	antenna away from the AC
	power cord if it is located
	nearby.

E-13