Philips SRU5107/27 user manual Keep updated for future devices, Learning commands

Example of DVD.

1Set up the remote control for a device (in this example DVD) as described in chapter 3.2.1 ‘Code search by brand’.

2Select DVD by pressing the DVD mode button for more than 1 second.

•The remote control sends out the ‘Select DVD’ command.

3Press and immediately release the SETUP button.Then press and immediately release the DVD mode button to select DVR.

•The remote control sends out the ‘Select DVR’ command.

Notes

•This method can be applied similarly to all Combo devices (TV / DVR,TV / VCR, DVD / DVR, etc.) and is available for all device modes.

•Note that this feature is not supported by all codes.

5Keep updated for future devices

5.1 Learning commands

The learning feature allows you to ‘learn’ the remote control functions from your original remote control.

For example: you may want to use your remote control to operate the RANDOM PLAY feature from your original CD remote control.

R

E

W

PO

ETUP

S

± 1 inch

	X
BL	U
	A
C
	D
	V
	D

	D
R	R	H
	C
V V
D
		T
	V	SA
	T

RN

EA

L

		T
	V	U
	T	P
E	E	N
T	IV	I
U
M	L

K

CT

E O

SEL

1Press and hold the SETUP button until the red light indicator turns on, then release the button.

2Press and release the desired mode button (TV, DVR, etc.).

•The red light indicator flashes, then remains lit.

3Press and release the LEARN button.

•The red light indicator flashes, then remains lit.

4Press and release the button on the SRU5107 that you wish to learn a new function (e.g. POWER).

5Point both remote controls facing each other by approximately 1 inch apart (refer to chapter 5.4 ‘Tips on learning’).

6Press and hold the button from which you wish to learn on the original remote control (e.g. POWER) until the red light indicator flashes once and then remains lit.

•If there is a learning problem, the red light indicator flashes for three seconds and then remains lit. If this happens, repeat steps 4 to 6.

7Repeat steps 4 to 6 for other buttons you wish to learn a new function.

8Press and release the SETUP button when all desired remote control commands have been learned.

•Code Learning is now complete.

10EN

129238_SRU5107_Short.indd 10 05-12-2008 15:38:2