2Getting started
2.1Inserting the batteries
•Insert 2 AAA type batteries,
noting the + and - configuration in the battery compartment.
Note
When replacing the batteries, all user settings will be retained in the remote control memory for 5 minutes.
2.2Setting up the universal remote control
The example below instructs you how to set up your universal remote control for your TV.
You can repeat the same steps for other devices (STB, DVD player/recorder and VCR) which you want to operate, using the SRP3004.
The remote control can be set up to operate any 4 of the following devices:
Device name | Description |
TV | Traditional TV, flat screen TV and |
| projection TV,TV part of TV / VCR,TV / |
| VCR / DVD and TV / DVD combos |
STB | Cable box, satellite receiver, Digital |
| Video Broadcasting Terrestrial device |
| |
| (IPTV), Free To Air TV, High Definition |
| Television decoder (HDTV) |
DVD | DVD player / recorder (DVDR), DVD / |
| Hard Disk Drive combination (DVDR- |
| HDD), |
| DVD player |
| TV / DVD,TV / VCR / DVD and VCR / |
| DVD combos |
VCR | Video cassette player / recorder,VCR |
| part of TV / VCR,TV / VCR / DVD and |
| VCR / DVD combos |
Example: setting up the universal remote control to operate your TV:
1 Switch ON the TV manually or use the original remote control for this. Tune to channel 1.
2 Press and hold the 
device selection button for 5 seconds until it blinks twice and then remains lit.
• The remote control is now in setup mode.
3Look up the
code for your brand in the brand list at the back of this user manual.
A
Use the digit buttons to enter the code for your brand.
• The | key will now |
| blink twice and then |
| |
| remains lit. |
| |
| If the key blinks twice fast, the code has not been | ||
| entered properly or the wrong code has been | ||
4 | entered. In this case, try again. | ||
Aim the remote control at | 30 sec. | ||
| the TV. Press and hold the |
| |
| button. Release it |
| |
| immediately release it as |
| |
| soon the TV switches off. |
| |
| • This may take up to 30 |
| |
5 | seconds. |
|
|
Switch ON the TV. |
| ||
| Try out the buttons you |
| |
| need for operating it.Try, for |
| |
| example, if the - PROG + |
| |
| and digit buttons function |
| |
| properly. |
|
|
• | If a button does not work as expected, press and hold | ||
| that button. Release it immediately as soon as it works. | ||
6 | For more information, see chapter 2.2.2. | ||
Press the | device |
| |
selection button twice to finish setup.
• When no button is
pressed for 2 minutes | 2 x | |
or more, the remote | ||
|
control will exit setup mode, automatically saving all your settings.
Getting started English
4 | EN | EN | 5 |