Philips SRP3004/10 manual Cassette in the VCR, Selection button Improving buttons, Device responds

Page 4

Important

If you made a mistake:

Press the device selection button twice to exit setup.

Restart from the beginning.

If the device does not respond at all or not to all of the button commands or if you cannot find the code for your brand, enter ‘9, 9, 9, 9’ in step 3 and continue with step 4. The remote control will now search its full database for a code that works with your TV. Full database search may take up to 15 minutes.

2.2.1 Setting up the remote control for other devices

1

(STB, DVD player / recorder and VCR)

Make sure the device is switched on and operational.

 

E.g. insert a disc in the DVD player / recorder or a video

2

cassette in the VCR.

 

Then follow steps 2 to 6 of ‘Setting up the remote

 

control for your TV’. Make sure to use the correct device

 

selection button: ,

or .

2.2.2 Improving buttons

When correctly set up, the remote control should be able to operate all your devices. However, when using the remote control for the first time it might occur that some buttons do not yet function as expected.

In this case you can have the remote control search for alternatives.

Note

Improving buttons is not possible when the code was found during full database search (with code ‘9, 9, 9, 9’).

During initial setup

1 Make sure the receiving device is able to respond.

E.g. when you try to repair the Play button for your DVD player, make sure to insert a DVD into the DVD player otherwise the Play button is not able to function.

2 Press the button that does not function, keep it pressed and immediately release it when the device responds. Repeat this for every button that does not function.

If the button still does not function as expected, try pressing it again for a longer period of time.

After initial setup

 

 

1

Make sure the receiving device is able to respond.

 

E.g. when you try to repair the Play button for your DVD

 

player, make sure to insert a DVD into the DVD player

2

otherwise the Play button is not able to function.

Select the device you wish

 

 

to operate (e.g. DVD).

 

 

Press the

device

 

 

selection button to select

 

 

DVD.

 

 

3

Keep buttons

and

5 sec.

 

pressed simultaneously for

 

 

5 seconds.

 

 

 

• The remote control is

 

4

now in setup mode.

 

Press and hold the button

 

 

that does not function and immediately release it when

 

the device responds.

 

If the button still does not function as expected, try

5

pressing it again for a longer period of time.

Press the

device

 

 

selection button twice to

 

 

save your settings and exit

 

 

setup mode.

 

 

 

• When no button is

2 x

 

pressed for 5 minutes

or more, the remote control will exit setup mode, automatically saving all your settings.

Getting started English

6

EN

EN

7

Image 4
Contents SRP3004/10 Table of contents Your SRP3004Getting started Setting up the universal remote controlInserting the batteries Remote control is Now in setup mode Cassette in the VCRSelection button Improving buttons Make sure the receiving device is able to respondUsing the universal remote control Buttons and functionsService and support Resetting a button to its original functionFrequently asked questions SetupHelpline OperationBatteries Need help?Brandlist Electro Tech 0908 1305 1768 3716 4136 White Westinghouse 32953349 4000Document order number 3139 235 5249 November RTP/4811