Philips SRU4008 Learning Commands, Clearing Commands, To Clear all Learned Commands under a mode

Learning Commands

The learning feature allows you to “learn” functions from your original remote control. For example - you may want to use your remote to operate the RANDOM PLAY feature from your original CD remote control. This remote is equipped with an “easy learning” feature that allows you to “learn” features (such as RANDOM PLAY from your original CD remote) by following the steps below, and on the next page:

1.Press and hold the SETUP button until the red indicator turns on, then release the button.

2.Press and release the desired mode button (TV, VCR, etc.), the red indicator blinks then stays on.

3.Press and release the LEARN button, the red indicator blinks then stays on.

4.Press and release the Learning Remote button that you want to teach (e.g. POWER).

5.Point both remotes facing each other by approxi- mately 1 inch apart (see tips on page 17).

6.Press and hold the Original Remote button (e.g. Power) until the red indicator blinks once and stays on. If there is a learning problem, the indicator blinks for three seconds and stays on. If this happens, repeat Steps 4 to 6.

7.Repeat Steps 4-6 for other buttons you want to learn.

8.Press and release the SETUP button when all desired remote commands are learned. Code Learning is now complete.

6.

Line up your remotes (that you’re learning from) in front of the Learning remote, on a hard surface approx. 1 inch apart.

4.

2.

1. 3.

20

Clearing Commands

To Clear all Learned Commands under a mode

Clearing learned commands is helpful if, for example, you replace your CD player with another brand or model. If you had learned a feature from your old CD player’s original remote on to this remote (such as RANDOM PLAY), that feature would no longer work for your new CD player. Should you wish to remove or clear one or more “learned” commands, follow the steps below:

1.Press and hold the SETUP button until the red indicator turns on. Release the SETUP button.

2.Press and release the button for the mode you want to clear (TV, VCR, etc.). The red indicator blinks off.

3.Press and release the LEARN button TWICE. The red indicator blinks off.

4.Press and release the SETUP button. The red indicator turns off. All learned Commands under that mode are now cleared.

Master Clear - To Clear all Learned Commands under all modes

1.Press and hold the SETUP button until the red indicator turns on. Release the SETUP button.

2.Press and release the LEARN button TWICE. The red indicator blinks off.

3.Press and release the SETUP button. The red indicator turns off. All Learned commands in the remote are now cleared.

21