Samson UT-5, UH-5, DA-5L manual Guided Tour UR-5/UR-5D Rear Panel

Guided Tour - UR-5/UR-5D Rear Panel

3:Unbalanced output* - Use this unbalanced high impedance (5K Ohm) 1/4” jack when connecting the UR-5 or UR-5D to consumer (-10) audio equipment. Wiring is as follows:

+SIGNAL

+SIGNAL

GROUND GROUND

4:Output Mixing switch (UR-5D receiver only) - When on, the outputs from both receivers are mixed together equally into a single monophonic signal which appears at both sets of balanced and unbalanced outputs.

5:Rear-mount antenna knockouts - The receiver antennas can optionally be mounted at these areas of the rear panel. Contact Samson Technologies for information about our rear-panel antenna mounting kit.

5

2

3

1

4

2

3

5

SAMSON MODEL No.UR-5D	BALANCED	UNBALANCED	AC INPUT			BALANCED	UNBALANCED
UHF SYNTHESIZED DIVERSITY RECEIVER	OUTPUT	OUTPUT		POWER 120V~ 50 / 60Hz 17W		OUTPUT	OUTPUT
	-10dBm.600Ω	-10dBv.5KΩ				-10dBm.600Ω	-10dBv.5KΩ
				RATING (120V-240V VOLTAGE SENSING)
				OUTPUT MIXING
SAMSON TECHNOLOGIES CORP.				ON	OFF
	RECEIVER 2					RECEIVER 1
HICKSVILLE, NEW YORK, U.S.A.

*If required, both the balanced and unbalanced outputs can be used simultaneously.

9