Samson UH-5, UT-5, UR-5D, DA-5L manual Setting Up and Using UHF Synth System

Page 18

Setting Up and Using the

UHF Synth System

The general procedure for setting up and using your UHF Synth System is basically the same regardless of the particular components you are using (i.e. UT-5 or UH-5; UR-5 or UR-5D):

1.Remove all packing materials (save them in case of need for future service) and mount the supplied “A” and “B” antennas to your receiver by inserting the BNC connector and twisting clockwise until snug.

Beltpack Transmitter

UT-5

SAMSON

UHFSynth Series

1a. If you are using the UT-5 beltpack transmitter, connect its antenna by inserting the wire and turning it clockwise until snug and then make the physical connection between its 6-pin plug and the lavalier micro- phone, headset microphone or instrument cable you are using (be sure to correctly set the “Mic/Instrument” switch). Because the 6-pin plug is “keyed,” you’ll need to rotate it a certain way to get it to “mate” with the connector mounted on the UT-5; then push straight down until you hear a click. To remove the 6-pin connector, lift up the outer sleeve and pull straight out (do not use force!). We recommend that you never pull on the wire, only the plug itself (with the outer sleeve lifted). If you are using a lavalier microphone, correct placement is critical to sound quality. We recommend that you place it as shown in the illustration above—as close to your mouth as possible but off to one side (to minimize nasality) and unobstructed by clothing. Bear in mind also that omni-directionalmicrophones (mics which pick up signal from all direc-

16

Image 18
Contents Samson Introduction System Features Guided Tours Glossary of Terms SpecificationsIntroduction Dbx is a registered trademark of Carillon Industries System Features System Features Guided Tour UR-5/UR-5D Front Panel Guided Tour UR-5/UR-5D Front Panel 5b 5d 5e 5c Guided Tour UR-5/UR-5D Rear Panel Guided Tour UR-5/UR-5D Rear Panel Guided Tour UT-5 Guided Tour UT-5 Guided Tour UT-5 Guided Tour UH-5 SamsonGuided Tour UH-5 Guided Tour UH-5 Setting Up and Using UHF Synth System Setting Up and Using UHF Synth System Setting Up and Using UHF Synth System Setting Up and Using UHF Synth System About dbx Noise Reduction About Tone SquelchTrouble-shooting Problem No soundProblem Distorted sound Cross-modulation interference Problem Sound fades as performer moves around sound dropout UHF Synthesized Frequency Chart Samson UHF Synthesized Frequency Chart A N N E LUT-5 Multi-pin Lavalier Wiring Guide GC-1 MC-1UT-5 Multi-Pin Wiring Chart Manufacturer Model No.Pin 1PinPin 3Pin 4Pin 5Pin About The DA-5L UHF Antenna Distribution Amplifier Guided Tour DA-5L Front Panel Guided Tour DA-5L Rear Panel AC InputSetting Up and Using the DA-5L Setting Up and Using the DA-5L DA-5L Grounding Techniques Glossary of Terms Glossary of Terms Specifications Transmitter RFTransmitter Audio Receiver DA-5LFCC Rules and Regulations