
EasyLink
loading data from TV; please wait
Virgin mode
Audio Language
English
Español
Français
English
Italiano
Press OK to continue
5Switch on the TV set.
6Insert one end of the supplied mains cable into the mains socket 4MAINS at the back of the DVD recorder and the other end into
the wall socket.
7A message appears on the screen announcing that the transfer has started. '' appears on the display during transfer.
The TV set transfers all saved TV channels, in the same order, to the DVD recorder.
This may take several minutes.
a'Time', 'Year', 'Month', 'Date' appears on the TV screen
Normally the date and time are taken from the data sent by the TV channel stored on programme P01. If th aerial signal is too weak or there is excessive interference, you should set the date and time manually:
1Check if the time in 'Time' is correct.
2If required, change the time with the number buttons 0..9 on your remote control.
3Select the next line with CH+ A or CH- B .
4Check if the displayed settings for 'Year', 'Month' and 'Date' are correct.
5 When all information is correct, save by pressing OK . | Problem |
aI can see more installation menus on my TV set
Not all the necessary data has been transferred. Please enter the settings by hand as follows. For more information on the various functions see 'Initial installation' in 'Installing your DVD recorder'.
1Select the desired audio language using CH- B or CH+ A and confirm with OK .
2Select the desired subtitle language with CH- B or CH+ A and confirm with OK .
3Select the desired screen format position using CH- B or CH+ A .
'4:3 letterbox' For a 4:3 TV set; cinema format (black bars above and below the picture)
'4:3 panscan' For a 4:3 TV set; full height format with the sides cut off
'16:9' For a 16:9 TV set
4Confirm with OK .
5Select the country of your residence with CH- B or CH+ A . If your country does not appear, select 'Other'.
6 Confirm with OK . | Problem |
Initial installation is now complete.
ENGLISH
Connecting the DVD recorder | 13 |
|