6. Manual recording
General information
Use 'Manual Recording' to make a sponta- neous recording (for example, a programme cur- rently being shown).
If you want to start and stop a recording manual- ly, read the section 'Recording without auto- matic
If you want to start a recording manually but have it stopped automatically, read the section
'Recording with automatic
Recording without automatic switch-off
1.Insert a cassette.
2.Use P+ 
P- to select the programme num- ber you want to record, for example, 'P01'.
3.To start recording, press RECORD/OTR I .
4.Stop recording with L C .
Recording with automatic switch-off (OTR One-Touch-Recording)
1.Insert a cassette.
2.Use P+ 
P- to select the programme num- ber you want to record.
3.Press RECORD/OTR I .
4.Each time you press RECORD/OTR I you will add 30 minutes to the recording time.
Preventing accidental erasing of cassettes
All cassettes (except for rental and store cas- settes) have a security tab on the back of the cassette.
To prevent recording over important recordings (erasing), you can remove this security tab.
If you later decide to record on a protected cas- sette, simply cover the hole with adhesive tape or slide the tab to the right.
Lining up recordings (assemble cut)
When you add a further recording to a cassette, which already has a recording on it, a short blank (flicker) can appear between the old and the new recording or the picture itself can flicker. To help reduce these from occurring, proceed as follows:
1.Find the tape position of the old recording where you want to insert the new recording.
2.Look at the last minute of the old recording (playback).
3.Press STILL 2 at the tape position where the new recording is to go and press
RECORD/OTR I .
4.Now start recording as usual by pressing 
on the remote control.
5.Stop recording with L C .
10 | EN |
|