Sony SS-FRF7ED, SA-WFT7 service manual SA-FT7ED/WFT7/SS-CNF7ED/FRF7ED/WS-FT7, Safety CHECK-OUT

Page 2

SA-FT7ED/WFT7/SS-CNF7ED/FRF7ED/WS-FT7

Mass

Approx. 1.6 kg (3 lb 8 oz)

with table top stand

Approx. 1.8 kg (3 lb 15 oz)

with wall mounting bracket

Approx. 1.7 kg (3 lb 12 oz)

SA-WFT7(subwoofer)

Speaker system

Active subwoofer,

 

magnetically shielded

Speaker units

Woofer: 15 cm (6 in.), cone

 

type

Enclosure type

Acoustically Loaded

 

Bass reflex

Reproduction frequency range

26 Hz – 200 Hz

Continuous RMS power output

250 W (4 ohms 100 Hz,

10% THD)

Input

LINE IN (input pin jack)

General

 

Power requirements

 

US, CND model:

120 V AC, 60 Hz

AEP, UK model:

220 – 240 V AC, 50/60 Hz

Power consumptions

65 W

 

0.3 W (standby mode)

Dimensions (w/h/d)

Approx. 175 610 298 mm

 

(7 24 1/8 11 3/4 in.)

Mass

Approx. 11 kg (24 lb 4 oz)

WS-FT7(speaker stand)

Dimension (w/h/d)

Approx. 130 635 30 mm

 

(5 1/8 25 1 3/16 in.)

 

(Diameter of base: 280 mm

 

(11 1/8 in.))

Mass

Approx. 5.7 kg (12 lb 9 oz)

Supplied accessories

SA-FT7ED:

Speaker cord (3.5 m) (3) Speaker cord (10 m) (2) Pin cord (2 m) (1)

Floor stand (2) (AEP, UK model) Terminal adapter (4)

Table top stand base (4) (US, CND model) Table top stand base (2) (AEP, UK model) Center speaker stand base (1)

Center speaker stand adjuster (1)

Wall mounting bracket (for the front/surround speakers) (4) Wall mounting bracket (for the center speaker) (1)

Wall mounting hook (10) Hex-head screw (8)

Screw (M5) (18) (US, CND model) Screw (M5) (10) (AEP, UK model) Screw (M4) (20)

Wrench (1)

L-adapter (1)

Sticker for the speakers (1)

Sticker for the terminal adapters (4) Cleaning cloth (1)

SAFETY CHECK-OUT

After correcting the original service problem, perform the following safety check before releasing the set to the customer:

Check the antenna terminals, metal trim, “metallized” knobs, screws, and all other exposed metal parts for AC leakage. Check leakage as described below.

LEAKAGE TEST

The AC leakage from any exposed metal part to earth ground and from all exposed metal parts to any exposed metal part having a return to chassis, must not exceed 0.5 mA (500 microamperes).

Leakage current can be measured by any one of three methods.

1.A commercial leakage tester, such as the Simpson 229 or RCA WT-540A. Follow the manufacturers’ instructions to use these instruments.

2.A battery-operated AC milliammeter. The Data Precision 245 digital multimeter is suitable for this job.

3.Measuring the voltage drop across a resistor by means of a VOM or battery-operated AC voltmeter. The “limit” indication is 0.75 V, so analog meters must have an accurate low-voltage scale. The Simpson 250 and Sanwa SH-63Trd are examples of a passive VOM that is suitable. Nearly all battery operated digital multimeters that have a 2V AC range are suitable. (See Fig. A)

To Exposed Metal

Parts on Set

0.15µF

1.5k

AC

voltmeter

 

 

(0.75V)

Earth Ground

Fig. A. Using an AC voltmeter to check AC leakage.

SS-FRF7ED:

Speaker cord (10 m) (1)

Terminal adapter (1)

Table top stand base (1)

Wall mounting bracket (speaker side) (1)

Wall mounting bracket (wall side) (1)

Wall mounting hook (2)

Hex-head screw (2)

Screw (M5) (4)

Screw (M4) (4)

Screw (for wall mounting bracket) (2)

Wrench (1)

Sticker for the speakers (1)

Sticker for the terminal adapters (1)

Cleaning cloth (1)

WS-FT7:

Cleaning cloth (1)

Design and specifications are subject to change without notice.

Abbreviation

CND: Canadian model

SAFETY-RELATED COMPONENT WARNING!!

COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN

THE PARTS LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.

ATTENTION AU COMPOSANT AYANT RAPPORT

À LA SÉCURITÉ!!

LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE 0 SUR LES

DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES PIÈCES SONT CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE REMPLACER CES COMPOSANTS QUE PAR DES PIÈCES SONY DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.

2

Image 2
Contents Speaker Stand WS-FT7 SpecificationsComponent Model Name Safety CHECK-OUT SA-FT7ED/WFT7/SS-CNF7ED/FRF7ED/WS-FT7Diagrams Table of Contents Servicing NotesDisassembly Exploded ViewsService Position SA-WFT7 Pry the cover with a scraper to aboid damage SA-FT7ED/WFT7/SS-CNF7ED/FRF7ED/WS-FT7 Section Disassembly TOP CoverPower Board AMP BOARD, Filter BoardBottom Cover B Assy Input BoardAcin Board SA-FT7ED/WFT7/SS-CNF7ED/FRF7ED/WS-FT7 Section Diagrams Circuit Boards LocationBlock Diagram LevelSemiconductor Location SA-FT7ED/WFT7/SS-CNF7ED/FRF7ED/WS-FT7 SA-FT7ED/WFT7/SS-CNF7ED/FRF7ED/WS-FT7 Location Side B IC B/D ~ ~ C111 IC601 TDA7570 AMP Board IC Pin Description FRONT/SURROUND Speaker Section SS-FRF7ED Screw +B Center Speaker Section SS-CNF7EDWasher 5.0, Nylon Speaker Stand Section WS-FT7 SW 5, TYPE2Screw +BVTP 3X8 TYPE2 IT-3 Subwoofer SA-WFT7COVER, TOP AEP,UK Screw +BVTP 4X16 TYPE2 IT-3CORD, Power US,CND CORD, Power UKCORD, Power AEP 201 A-1119-012-A Cabinet ASSY, SpeakerBRACKET, Base Section SmallAcin AMP AMP Filter Diode RD15ESB2 PLUG, Connector 3P DiodeDiode RD6.2ESB2 Diode RD15ESB2 Ferrite BeadFilter Input LED Power Power SW Parts for Installation and Connections AccessoriesCLOTH, Cleaning SEAL, BlindSUPPLEMENT-1 Discrimination Acin Board SW Board LED BoardTable of Contents Diagrams SA-FT7ED/WFT7/SS-CNF7ED/FRF7ED/WS-FT7 Section Diagrams Printed Wiring Boards Filter Section AMP BoardSA-FT7ED/WFT7/SS-CNF7ED/FRF7ED/WS-FT7 Printed Wiring Board AMP /2 Printed Wiring Board AMP /2 BLKSchematic Diagram AMP Section Printed Wiring Boards Power Section ~ ~Schematic Diagram Power Section Acin AMP AMP Filter C507 131-686-31 Ground Terminal EP151 1-537-770-21 Terminal BOARD, Ground SWITCH, Slide PhaseBass Boost Photo Coupler PowerSWITCH, Power Power SA-FT7ED/WFT7/SS-CNF7ED/FRF7ED/WS-FT7 Revision History

SA-WFT7, SS-FRF7ED specifications

The Sony SS-FRF7ED and SA-WFT7 speaker system represents a harmonious blend of cutting-edge technology and superior audio performance, designed to elevate your listening experience. The SS-FRF7ED is a part of Sony's renowned line of floorstanding speakers, offering a powerful combination of elegance and robust sound. With a sleek design, the SS-FRF7ED can seamlessly integrate into any home environment while delivering stunning acoustic clarity.

One of the standout features of the SS-FRF7ED is its three-way configuration, which includes a high-frequency tweeter, mid-range driver, and dual bass drivers. This arrangement ensures that a wide frequency range is covered, allowing for rich highs, clear mids, and powerful lows. The frequency response is impressive, providing a listening experience that caters to various music genres, whether it be classical, rock, or electronic.

The speaker uses Sony's advanced Magnetic Fluid technology, which enhances the overall sound quality by reducing distortion and improving response times. This technology allows for greater dynamic range and ensures that even the most subtle nuances in music are accurately reproduced. The SS-FRF7ED also utilizes optimized bass reflex design, enabling deeper bass performance while minimizing air turbulence, resulting in clean and punchy bass response.

Complementing the SS-FRF7ED is the SA-WFT7 subwoofer, specifically engineered to provide deep, immersive bass that enhances any audio experience. The SA-WFT7 features a high-efficiency amplifier that delivers powerful output without compromising clarity. Its front-firing design and large diameter cone ensure that low frequencies are reproduced with full-bodied detail, making it an ideal partner for movie soundtracks and music alike.

Both the SS-FRF7ED and SA-WFT7 are designed with user convenience in mind. They come equipped with speaker terminals that facilitate easy integration with various audio systems, allowing users to create a comprehensive home theater setup. These speakers also feature a stylish finish that not only enhances their aesthetic appeal but also protects against dust and scratches.

In summary, the Sony SS-FRF7ED and SA-WFT7 speaker combination is an excellent choice for anyone looking to enhance their audio setup with high-quality sound and innovative technology. Whether you’re watching movies, listening to music, or playing video games, the superior performance and advanced features of this speaker system promise to deliver a captivating auditory experience.