Visible and invisible laser radiation when open. Avoid exposure to beam.
Do not touch the disc optical lens inside the disc compartment.
on power cords or on other electrical equipment.
If the product is transported in temperatures below 5°C, unpack the product and wait until its temperature matches room temperature before connecting it to the power outlet.
space. Always leave a space of at least four inches around the product for ventilation.
never cover the ventilation slots on the product.
Do not mix batteries (old and new or carbon and alkaline, etc.).
Remove batteries if they are exhausted or if the remote control is not to be used for a long time.
Batteries contain chemical substances, they should be disposed of properly.
The product/remote control may contain a coin type battery, which can be swallowed.
Keep the battery out of reach of children at all times!
CLASS 1
LASER PRODUCT
Important notes for users in the U.K.
Mains fuse
This information applies only to products with a UK mains plug.
molded plug. If you replace the fuse, use one with:
the ratings shown on the plug, a BS 1362 approval, and
the ASTA approval mark.
Contact your dealer if you are not sure about what type of fuse to use.
Caution:To conform with the EMC directive (2004/108/EC), do not detach the plug from the power cord.
How to connect a plug
The wires in the power cord are colored as follows: blue = neutral (N), brown = live (L).
If the colors do not correspond with the colors on your plug, identify the terminals in your plug as follows:
1Connect the blue wire to the terminal marked N or colored black.
2Connect the brown wire to the terminal marked L or colored red.
3Do not connect either wire to the earth terminal in the plug, marked E (or e) or colored green (or green and yellow).
Before you replace the plug cover, make sure that the cord grip is clamped over the sheath
the cable.
Copyright in the U.K.
Recording and playback of material may require consent. See Copyright Act 1956 and The Performer’s Protection Acts 1958 to 1972.
20EN