Channel Installation Adding Channels Manually

CHANNEL INSTALLATION: ADDING CHANNELS (MANUALLY)

	uto Programming (see previ-
	Aous page) adds all the chan-
	nels it can find (on your Antenna
	or Cable TV system) into the TV's
	memory. You may add other chan-
	nels, or drop unwanted channels
	from the list of channels in the
	TV's memory.
	BEGIN
1	With the Channel
	Installation Menu onscreen
	press the Menu button, or use
	the Cursor (▲) Up and Down
	(▼) buttons, to select CHANNEL
	with the TV’s highlight control
2	bar.
	Press the Number, or CH(+,-),
	buttons to select the channel you
	want to SAVE (or DELETE).

CHANNEL INSTALLATION
CHANNEL	TV	4
CHANNEL RING	DELETED
INPUT	ANTENNA
LABEL	(	)
AUTO PROGRAM
EXIT

			VOLUME	CHANNEL
POWER	VIDEO	L AUDIO R	A V SWITCH

CHANNEL INSTALLATION
C H A N N E L	TV	4
CHANNEL RING	SAVED
INPUT	ANTENNA
LABEL	(	)
AUTO PROGRAM
EXIT

Press the Menu, or Cursor

Down (▼), button to select

CHANNEL RING with the high-

light control bar.

Press the Cursor Right (▶) or

Left (◀ )button on the remote

to SAVE (or DELETE) the select-

ed channel number into memory.

Repeat steps 2-4 for each channel

you wish to add (or delete).

	5
					POWER	2
3		SLEEP
		A/CH	STATUS/EXIT	CC	CLOCK		CHANNEL INSTALLATION
							CHANNEL	TV	1
	TV	RECORD			TV/VCR		CHANNEL RING	SAVEDFRONT
1	VCR	1	2		3		INPUT	ANTENNA		AUX
		1	2		3		INPUT	ANTENNA		AUX
	ACC	4	5		6	4	LABEL	(	)	SVIDEO
			5				EXIT
							AUTO PROGRAM
		7	8		9
		SMART			SMART
			0
		SOUND			PICTURE
		MENU			SURF

Press the STATUS/EXIT button
to remove the menu when you are
finished.	STOP

SMART HELP

Try it out. Press the

CH(annel) +, - buttons.

The channels you SAVED should appear. The channels you DELETED should not appear.

If you need to SAVE (or DELETE) a channel above 100, use the CH (+, -) buttons. The consumer remote control number buttons can not select channels above 99 (unless the 3 DIGIT ENTRY Commercial mode Menu control has been set to receive such channel entries).

VOL

MUTE

Remember, you may add the FRONT (A/V); AUX(iliary); and S-VIDEO inputs into the TV’s channel scan program memory. Then, by pressing the CH(annel) +, - buttons you may quickly select the Audio/Video Input jacks on the front and rear of the TV.

Select CHANNEL in the onscreen menu, then press the CH (+, -) buttons to select either FRONT (A/V)/ AUX(iliary)/ or S-VIDEO inputs. Note: The AUX(iliary) Video modes are located between the lowest and highest channel numbers within the CHANNEL con- trol.