Installing your television set | (Diagrams are for illustration only. |
May differ from actual TV sets) | |
Positioning the television set | Remote control |
10 cm
10 cm | 10 cm | ||||
|
|
|
|
|
|
Place your TV on a solid, stable surface, leaving a space of at least 10 cm around the appliance.
Connections
Insert the two
The batteries supplied with this appliance do not contain mercury or nickel cadmium.
If you have access to a recycling facility, please do not discard your used batteries (if in doubt, consult your dealer).
Switching on
•Insert the aerial plug into the x socket at the rear of the set.
If you are using an indoor aerial, reception may be difficult in certain conditions. You can improve reception by rotating the aerial. If the reception remains poor, you will need to use an external aerial.
•Insert the mains plug into a wall socket. Diagram may differ from the actual plug.
To switch on the set, press the on/off key. A red indicator means that the television is on standby mode. Refer to the next page on ‘Remote Control keys’ for the various keys that you could use to switch on the set An indicator light will flash when it is receiving signal from the remote control.
The keys on the TV set
The television set has 4 keys which are located at the top/or front.
The VOLUME increase/decrease key is used to adjust the sound levels.The CHANNEL up/down key is used to select channels.
To access or exit the main menu, press down theVOLUME increase/decrease keys, simultaneously.
To select an item in the main menu, press the CHANNEL up/down key.
To select an adjustment, press down the VOLUME increase/decrease key.
Installation | Operating instruction | 3 |
3 | 12/28/04, 10:52 AM |