Installing your television set, Program sort

Installing your television set

æ Â ê ®

Insert the aerial plug into the : socket at the rear of the set.

Insert the mains plug into a wall socket (220-240 V / 50 Hz).

Insert the two R6- type batteries (supplied) making sure that they are the right way round.

To switch on the set, press the on/off key. If the television remains in standby mode, press P # on the remote control.

The first time you switch on the television, a menu appears on the screen and the tuning starts automatically.

• ••••••••••••••••••••••••••••••••

If the menu is not displayed, press and hold down the ”- and ”+ keys on the TV set for 5 seconds to start the tuning.

&All the available TV programmes will be stored. This operation takes a few minutes.The display

shows the progress of the search and the number of programs found. At the end of the search, the menu disappears.

If no programme is found, see Tips chapter at the end of the instruction for use.

éIf the transmitter or cable network sends the automatic sort signal, the programs will be numbered correctly. In this case, the

“If this is not the case, you need to use the Sort menu to number the programs correctly. Some transmitters or cable networks broadcast

their own sort parameters (region, language, etc.). In this case, indicate your choice using the îÏ keys and validate with ¬.

&Press key H.The Main menu is displayed on the screen.

éWith the î key, select Manual Store and press ¬.

“Use the 09 or @P# keys to select the program you wish to renumber.

‘Then use the Ï key to select Program No and enter the new number with the È¬

keys.

(With the Ï key, select Store and press ¬. § Repeat steps “ to ( for each program you

wish to renumber.

è To quit the menus, press d.