BASIC ANTENNA SIGNAL CONNECTIONS
ANTENNA
SMART
Acombination antenna receives normal broadcast channels
(VHF
BEGIN
If your antenna has a round
cable (75 ohm) on the end, then you're ready to connect it to the TV.
If your antenna has flat twin-lead
wire (300 ohm), you first need to attach the antenna wires to the screws on a 300 to 75 ohm adapter.
Push the round end of the adapter (or antenna) onto the 75Ω plug on the rear of the TV. If the round end of the antenna wire is threaded, screw it down tight.
Note: For homes with separate UHF and VHF antennas you will need an optional combiner to connect to the TV.
U/V
Combiner
75 V
Back of TV
HELP
Remember: Be sure to set the TV for the type sig- nal you've connect- ed (see the “Cable” section on page 11 of this manual.)
To set the TV to select only the chan- nel numbers in your area see how to “Program" or "Add" channels in the TV’s memory on page 12 (Auto Program sec- tion).
To order any option- al accessory contact your dealer or the Philips Parts Center at
75 V
Back of TV
Combination VHF/UHF
Antenna
(Outdoor or Indoor)
300 to 75Ω
1 Adapter
Twin Lead
Wire
OR
Round Cable 75Ω
2
75V
6