Sony SA-NS300 operating instructions Introduce your speaker to your router, On back of speaker

Sony® Wireless Network Speakers

Easy to set up. Easy to use.

PC or Mac, play music anywhere your Wi-Fi®goes—even outside.

SA-NS300 SA-NS400 SA-NS500

STEP 1: Introduce your speaker to your router.

Before you begin, make sure your router and computer are on and connected.

OPTION 1: Automatic Wired Set-up (easy 2-step method)

1.Turn speaker on:

SA-NS300, SA-NS400

On back near base.

SA-NS500 (2 buttons)

On bottom.

Both buttons need to be in the up position for sync only.

2. Connect speaker and computer to router.

Ethernet Router/

Cable Access Point

(included)

To

Computer

When “LINK” light on speaker turns orange, unplug the cable. System will reboot/sync to Wi-Fi®(green light).

OPTION 2: “WPS” Push-buttonSet-up(Wi-Fi®Protected 3-step method)

1.Turn speaker on:

SA-NS300, SA-NS400

On back near base.

SA-NS500 (2 buttons)

On bottom.

Both buttons need to be in the up position for sync only.

2. Press “WPS” button	3. Press/hold “WPS”
on router:	button (for 3 sec.)
Router/Access Point	on back of speaker

The WPS button may vary.

Check your router manual.

When “LINK” light on speaker turns orange, system will reboot/sync to Wi-Fi®(green light).

IMPORTANT NS500 ONLY: After connection is made, switch bottom button down to NETWORK STANDBY MODE to play.

Additional set-up methods for any router, computer and most operating systems are detailed in the operating instructions manual in the box. Also enclosed is a Quick-Start Guide for PC and Mac.