Connect extra loudspeakers/amplifier
REAR multimedia loudspeakers
&Select Surround speakers On in the Setup menu, see p. 8.
éConnect the audio cables to the rear loudspeakers and to the Dolby Surround output SURROUND OUT at the back of your TV. There is only one output for both speakers.
“Adjust the volume of the rear loudspeakers. Use the Test tone function in the Speakers menu, see p. 8.
Note: Once you have adjusted the volume of the rear loudspeakers, do not change it while watching TV as the whole configuration operates with the volume adjustment of your TV.
(Analogue) Multichannel surround receiver
&Connect a MultiChannel surround receiver to the AUDIO OUT R and L connectors at the back of your TV.
éIf you want the loudspeakers of your TV to act as centre speaker, also connect an audiocable to the MultiChannel surround receiver CENTRE OUT connector and to the CENTRE IN connector at the back of your TV.
“Select Centre input On in the Source menu. See p. 10.The loudspeakers of the TV will now only produce centre sound.
‘If necessary, adjust the volume level of the centre sound in the Centre in volume menu item of the Source menu.The overall volume has to be controlled via the MultiChannel surround receiver.
To select connected equipment
Press the v key on the remote control repeatedly to select EXT1, EXT2, EXT3, EXT4 or SIDE according to where you connected your equipment at the back or the right side of your TV.
Remark : Most equipment (decoder, recorder) carries out the switching itself, when it is switched on.
Cinema Link surround receiver
See the separate supplied Cinema Link instruction manual.
Attention: the sound info on screen will not correspond with the actual sound reproduction.
Recorder or DVD with EasyLink
The recorder (VCR or DVD+R(W)) or DVD can be operated with the remote control via the Recorder or DVD menu on screen.
Recorder
Òp ‡ π † ® Ï
Rwd Play Stop Play Ffw Rec Eject
&Press the MENU key on the remote control.
éSelect the Recorder or DVD menu with the cursor up/down.
“Press the cursor left/right, up/down to select one of the recorder or DVD functions.
DVD 
Òp ‡ π † Ï
Prev. Play Stop Play Next Eject
The key ® for recording can be operated in the TV mode.
If your EasyLink recorder has the system standby function, when you press the B key for 3 seconds, both TV and the recorder are switched to standby.
21