Philips VRX775VD manual Important Safety Instructions

Page 3

IMPORTANT SAFETY INSTRUCTIONS

Read before operating equipment

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with a dry cloth.

7.Do not block any of the ventilation openings. Install in accordance with the manufacturers instructions.

8.Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or ground- ing-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and third grounding prong. The wide blade or third prong are provided for your safety. When the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

11.Only use attachments/accessories specified by the manu- facturer.

12.Use only with a cart, stand, tripod, bracket, or table

specified by the manufacturer, or sold with the app-

aratus. When a cart is used, use caution when moving the cart/apparatus combination to avoid

injury from tip-over.

13.Unplug this apparatus during lightning storms or when unused for long periods of time.

14.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

15.This product may contain lead and mercury. Disposal of these materials may be regulated due to environmental con- siderations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance: www.eiae.org

16.Damage Requiring Service - The appliance should be serviced by qualified service personnel when:

A.The power supply cord or the plug has been damaged; or

B.Objects have fallen, or liquid has been spilled into the appliance; or

C.The appliance has been exposed to rain; or

D.The appliance does not appear to operate normally or exhibits a marked change in performance; or

E.The appliance has been dropped, or the enclosure damaged.

17.Tilt/Stability - All televisions must comply with recommend- ed international global safety standards for tilt and stability properties of its cabinet design.

• Do not compromise these design standards by applying excessive pull force to the front, or top, of the cabinet which could ultimately overturn the product.

• Also, do not endanger yourself, or children, by placing electronic equipment/toys on the top of the cabinet. Such items could unsuspectingly fall from the top of the set and cause product damage and/or personal injury.

18.Wall or Ceiling Mounting - The appliance should be mounted to a wall or ceiling only as recommended by the manufacturer.

19.Power Lines - An outdoor antenna should be located away from power lines.

20.Outdoor Antenna Grounding - If an outside antenna is connected to the receiver, be sure the antenna system is grounded so as to provide some protection against voltage surges and built up static charges.

Section 810 of the National Electric Code, ANSI/NFPA No. 70-1984, provides information with respect to proper grounding of the mats and supporting structure grounding of the lead-in wire to an antenna discharge unit, size of grounding connectors, location of antenna-discharge unit, connection to grounding electrodes and requirements for the grounding electrode. See Figure below.

21Object and Liquid Entry - Care should be taken so that objects do not fall and liquids are not spilled into the enclo- sure through openings.

Note to the CATV system installer: This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

Example of Antenna Grounding

as per NEC - National Electric Code

GROUND CLAMP

ELECTRIC SERVICE EQUIPMENT

ANTENNA LEAD IN WIRE

ANTENNA DISCHARGE UNIT (NEC SECTION 810-20)

GROUNDING CONDUCTORS (NEC SECTION 810-21)

GROUND CLAMPS

POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART 250, PART H)

3

Image 3
Contents For fast help, call us first Warranty Verification Important Safety Instructions Table of Contents Connect the Cable TV cable to If your Cable TV signal is a singleHooking UP Your TV Basic Cable TV Connections If you have a Cable Converter BoxOhm on the end, then youre ready to connect it to the TV If your antenna has flat twin-lead wireHooking UP Your TV Basic Antenna TV Connections If your antenna has a round cableConnect the yellow video cable from Connect your Antenna or Cable TV signal to the in fromHooking UP Your TV Basic TV to VCR Connections Front A/V InputsRemote Basic TV/REMOTE Operations TelevisionDescription of Remote Control Buttons Press the Cursor Right When finished, press the StatusPress the Menu button on Press the Cursor UP orCable , or Auto mode HOW to USE the Tuner Mode ControlHOW to Automatically Program TV Channels If on is selected the channel is Scroll down using the CursorWith the Channel Edit Options displayed , and Channel CH + or buttons you wish to addPress Cursor UP or Down HOW to USE the Picture Adjustment ControlsWhen finished, press the Status Press the Menu button onPress the Cursor Right HOW to USE the DNR Noise Reduction ControlButton turn the DNR feature on or OFF Press the Cursor UP orSOR Down button until the word HOW to USE the Contrast + Black Stretch ControlButton turn the Contrast + feature Press the Cursor UP or CURWords Bass Boost or Treble HOW to SET the Bass and Treble Boost ControlsSound menu features until Press the Cursor UP or Cursor Down button to scrollHOW to USE the AVL Automatic Volume Leveler Control Press the Cursor UP or CUR SOR Down button until the wordPress the Cursor UP or CUR SOR Down button to scroll Press the Clock button on HOW to the Timer ControlsUnderstanding the Autolock Controls Over the next few pages you’ll learn how to block channelsSetting UP the Autolock Access Code Blocked with Block Channel HOW to Block ChannelsEnter your Access Code to View a tuned channel that isHOW to Clear ALL Blocked Chanels AT the Same Time HOW to Block ALL Channels AT the Same Time Press the Cursor UP or Down button until AutoLock is Blocking Programming Based on Movie RatingsBlocking Programming Based on TV Ratings Down button to highlight the desired ratingTV Ratings Rating Sub-Menus Blocking Options Using the Autolock Blocking OptionsHOW to USE the Closed Caption Control Press the Sleep button repeatedly Press the Sleep button onPress the Auto Picture button Setting the Auto Picture ControlSetting the Auto Sound Control Press the Auto Sound button onPress the Auto Sound button Press the corresponding COL Ored Red, Green, Yellow or Blue While the Smiley face channel Indicator is displayed, pressPress the Channel + or but Press the Smiley Button onUsing the Quadra Surf Buttons Repeatedly pressing the same COLFrownie face button will allow you TV Displays Wrong Channel or No Channels Above Troubleshooting TipsGlossary to Television Terms Index Renewed